|Prev||Professional Automotive Repair Technical Discussions for September 16, 2011
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2004 Chrysler Sebring Touring 2.7L mode door and blend door VIN: 1C3EL56R94
Have tested the wires at the back of the c.m. and they seem to be reading right, but it seems as though my motor books do not cover this car for the acuators. have tested the mode door with a knowen good part and it is not moving.
|2000 Jeep Wrangler SE 4.0L Poor Idle Quality, Hesitation, Surge, Cuts out, Stall, Misfire, MIL Lamp on VIN: 1JFA49S5YP
This thing starts fine and then after it warms up a little (not much) it starts running rough and it will set p1296 map volts sensor low. running on graphing multi meter you can see hash lines that drop below .100 millivolts (hence this is why its setting the ... Trouble codes: P1296 (Map volts too low)
Fixes & Summaries for Chrysler
|2002 Dodge Dakota 4.7L Alternator VIN: 1B7GG32N32
So in fear of putting in a PCM in this vehicle and being wrong, I came in early to work (no phones or customers). I checked every wire, ground and fuse. According to the Mitchell flow chart the field wire was shorted to ground, but I disagreed by using common ...
|2001 Jeep Cherokee Classic 4.0L Cooling Systems VIN: 1J4FF38S61
customer declined any further repairs.going to get rid of it.thanks for all the info.i think the problem is in the head.