|Prev||Professional Automotive Repair Technical Discussions for September 17, 2011
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1985 Chrysler Laser XE 2.2L Poor Idle Quality, Hesitation, Surge, Misfire, Poor Fuel Economy VIN: 1C3BA54E3F
hey guys. I need some help with this one. This one came in for a low power during acceleration and rough idle. I checked the timing with the ect sensor disconnected and it's @ +15deg, so I adjusted down to 12deg, no change. Checked spark plugs and it had Bosch...
|2007 Chrysler Sebring 2.4L No Start VIN: 1C3LC56K27
Car was towed in, cranks over fine, but will not start. Fuel pressure is good, has NO injector pulse or ignition pulse. Injectors and coil packs have power 12.6v (11v during cranking) but the ground is not being pulsed by the PCM. Cam and crank sensors are get...
Fixes & Summaries for Chrysler
|2001 Dodge Dakota 3.9L Poor Idle Quality, Misfire VIN: 1B7GL22X01
Thank you all for your advice on solving my dakota problem. I did another back pressure test while driving down the road (as suggested) and I saw about 5-7 psi with some higher spikes at times from the left bank. I replaced the catayltic converter asssembly,... Trouble codes: P0301, P0303, P0300.
|2003 Dodge Sprinter 2500 2.7L Stall VIN: WD2YD74233
This vehcile is only 1/2 fixed. When in came in, it would cut off under slight acceleration when warm and not restart. After we installed the high pressure pump and cleaned the fuel tank, it cuts off very intermitentley under heavy acceleration when warm. Sinc...
|2007 Dodge Caliber R/T 2.4L MIL Lamp on VIN: 1B3HE78K57
No complaints yet, consider it fixed. Excellent info from Rick in Illinois. I encourage everyone searching read that.The fluid was trashed, so we changed filter, flushed the cooler and refilled with new CVT fluid.I am thinking that the fluid had lost all of th... Trouble codes: P0218 (P0218-high temperature operation activated).