 Prev |
Professional Automotive Repair Technical Discussions for July 4, 2011 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 1998 Chrysler Grand Voyage 3.3L Poor Idle Quality, Stall, MIL Lamp on VIN: 1C4GHB4R2W checked all inputs again into ecu with ignition, Bat supply and grounds etc steady even though ASD relay still clicking. dis-connected as much as possible loom wise and sensor wise with no difference to ASD relay clicking so concluded fault lay in ecu itself. ... Trouble codes: P1685 (invalid skim message), P0351 (ignition coil No1 primary circuit), P0352 (ignition coil No2 primary circuit), P0253 (ignition coil No3 primary circuit), P0202 (Injector No2 control circuit), P0203 (Injector No3 control circuit). |
17 | |
| 1993 Dodge Caravan SE 3.3L No Start Thank you everyone for taking the time out of your busy schedules to help me. What I ended up doing was checking for play in the timing chain. This van is very hight mileage and many of you suggested this. The chain has a lot of play so I am assuming this is c... |
14 | |
| 1999 Dodge Grand Caravan SE 3.3L Mechanical VIN: 1B4GP44R8X hello guys, thank for the reply,i think i will rebuld the same engine the information you all provided were correct to avoid wasting time i will rebuld it again thanking you all . |
8 | |
| 2000 Dodge Grand Caravan ES 3.8L Ccd Bus VIN: 1B4GP44L3Y Well after over 6 hours of tail chasing the vehicle is down the road. I am sure everyone has experienced a diagnostic problem that seemed to repair itself. I wanted to wait a couple of weeks before closing this request to make sure the problem didn't resurface... |
11 | |
| 1997 Plymouth Voyager 3.0L Stall VIN: 2P4FP2531V Hello all, my apoligies for not closing this, but I have been extremely busy and had almost forgotten about it, I had tried a few of your suggestions all with no luck, so I started taking movies with the Solus and going over all the data frame by frame when it... Trouble codes: 306 (Cylinder 6 misfire). |
10 |
