|Prev||Professional Automotive Repair Technical Discussions for July 4, 2011
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Asian
|2003 Honda Civic EX 1.7L both fans inop VIN: JHLRD28431
ok honda techs here is 1 for you i have this 03 civic that both fans are inop went into live data and found ect -40c iat -40c tps nothing 0.0 volts i seen in the diagram that all 3 are running off of a green/yellow wire may be backwards but anyway cust had to ...
|2004 Toyota Sienna LE 3.3L Pressure VIN: 5TDZA23C54
Hello all, thanks again for reading this. Just a quick one, we replaced condenser on this Sienna and after recharging fully, after warm up, AC performance diminishes, an compressor starts to kick on and off right away. When I put the gauges on - pressures are ...
|2009 Toyota Land Cruiser 5.7L Accelerator VIN: JTMHV09J59
the engine starts well but the accelerator stops at 2000 and the mil is ever on. please be aware that the engine is 1VD FTV and it is diesel.
Fixes & Summaries for Asian
|1988 Honda Accord LXi 2.0L MIL Lamp on VIN: 1HGCA6287J
Thank you very much for the assistance. I found the o2 sensors to be working properly. After I cleared the code and road tested, the code for the coolant sensor came up and after that tested good and the circuits to the ecm tested good, the flow chart said to ... Trouble codes: 2?.
|2003 Nissan Altima S 2.5L timing chain VIN: 1N4L11D73C
I now know why I do NOT like asian cars, THEY ARE HORRIBLY EXPENSIVE TO REPAIR, this Altima required about 3 times as much money as most American cars Thanks to Larry [...] we got it done,not really to my satisfaction b...
|2002 Suzuki XL-7 Touring 2.7L AC specs VIN: JS3TX92V02
Thanks for all the help, especially the heads up on the tensioner pulley recall! Capacity is as follows-- Single unit 500 gm +/-50gm or 1.1# +/-.1# Dual unit 750 gm +/-50gm or 1.65# +/-.1# This is one of the best ideas ever!!! Instead of a Receiver/Dryer, t...