× Auto Repair Pros Member Benefits TechHelp Knowledge Base Forums Resources My iATN Marketplace Chat Pricing About Us Join Industry Sponsors Video Members Only Repair Shops Auto Pro Careers Auto Pro Reviews
Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for May 8, 2010
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
2003 Ford Escape XLT 3.0L MIL Lamp on VIN: 1FMCU93103
after we replace cat and o2 sensor we test drive all ok check for ready status all ok 2 weeks later car came back with same code po430 i really need some help here Trouble codes: P0430
View
2005 Ford F-250 Super Duty FX4 6.0L No Start, Extended crank VIN: 1FTSW21P45
All you Ford 6.0 guys I need your help. The story is below but here is my question: When doing the air pressure test through the ICP sensor port I have air escaping from the port in the back of the high pressure pump. I have 12V to the IPR. This is the same po... Trouble codes: P0284, P2290 (ICP too low), P2291
View
1995 Mercury Grand Marquis GS 4.6L injector pulse
I have tested fuel pressure koeo 45 spark goood fuses good.noid light nolight untill key in run possition,then light will flashremoved ign switch nothing looks burnt. Im suspecting injector driver mod in computer any ! seen this before thankds for all replies....
View

Fixes & Summaries for Ford
Fix/Summary Answers
1993 Ford Ranger XL 3.0L Brake pull VIN: IFTCR10U2P
Hey guys, thank so much for your help. we ended up replacing both rear wheel clyinder and the pull went away. customer drove the truck on a 2 hr trip yesterday at higher speeds and said he had zero pull. again thanks for the help IATN
21
1996 Ford Contour GL 2.0L Poor Idle Quality, Hesitation, Surge, Stall, MIL Lamp on VIN: 1FALP6539T
I hate to say it, but this one was fixed with a new MAF sensor. It turns out that I had misread the Baro reading in data stream, and it was actually not ok. As I said before, it had a Cardone reman MAF when I got the car, but I replaced it with another Cardone... Trouble codes: P0171.
14
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next