 Prev |
Professional Automotive Repair Technical Discussions for June 28, 2009 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 2002 Ford F-250 Super Duty Lariat 7.3L master cylinder VIN: 1FTNW21FX2 AFTER INSTALLING A REBUILT MASTER CYLINDER SEVERAL TIMES THE BRAKE PEDAL WOULD SOMETIMES GO FARTHER DOWN DURING A STOP THAN HAD PREVIOUSLY BEEN NOTICED. THE PEDAL WOULD EXHIBIT A RANDOM STROKE BEFORE APPLYING THE BRAKES AND PROGRESSIVELY GET WORSE OVER TIME UN... |
View | |
| 2006 Ford F-150 XLT 5.4L MIL Lamp on VIN: 1FTPW14V56 Help Brothers I'm sinking in the Ford sea. Truck came in with a complaint of No Tach, Speedo, A.B.S. light on, Ck engine light on, No A/C clutch operation, and battery light on. I hooked up Modis and got no communication with the P.C.M or the A.B.S. module, I ... Trouble codes: U1900 |
View | |
| 2006 Ford F-550 Super Duty XLT 6.0L No Start VIN: 1FDAF56P26 I am working on a 2006 F-550 6.0 that did not start. Checked engine oil pressure low side and there was no pressure. Removed and checked low pressure pump found pump and front cover damage, a new low pressure assembly was installed. Engine now starts okay when... |
View | |
| 1993 Mercury Sable GS 3.8L motor idle VIN: 1MELM5041P this motor starts good idles up good and then as it warms up starts to idle rough . does not go into cloosed loop unless I rise idle up to say 1500 or give a shot of carb spray into intake to wake uo o2 sensors. they sit at idle almost dead. .02 volts or less ... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 2006 Ford F-150 XLT 4.6L Noise VIN: 1FTRW12WX6 Removal of headers, at first there were no signs of any cracks. A closer inspection showed hair line cracks along a couple of welds around the collectors, after tapping just a little bit with a hammer you could see the cracks move. That was the problem. For th... |
8 |
