|
|
1997 Chrysler Concorde 3.5L No Start, Stall, Floods
The only thing I can find abnormal is when the car is going
to stall the vacuum and rpms start to drop 5"hg and the
inj. ms climb to 32ms and the car floods (happens only cold
and in open loop!!!...) Have to hold throttle to floor
(clear flood) to start it aga... Trouble codes: P0403 (EGR Solenoid Circuit - open or short). |
View |
|
1999 Chrysler 300M 3.5L Stall, Misfire, MIL Lamp on, hard start
This is a strange problem. Customer had the car towed in
because it was spitting aand sputtering(it happened all of
a sudden while climbing a small hill). He had it flatbedded
in the evening. Next day I started it to test drive and
vehicle was running very smo... Trouble codes: p0300 (multiple misfire). |
View |
|
2004 Chrysler PT Cruiser 2.4L Stall
car came in on a tow truck ...customer claim it stalled
during idling in frt of the traffic lite...we attempted
to start the car and experienced with start not kickin
in...tried with remote started ...engine will spin but not
spark...at this poit in time i viv... |
View |
|
1995 Dodge Neon 2.0L Hesitation, Cuts out
Replaced Pcm for a stall/reset problem- reman pcm from
Mopar- actual tps value(.61v) does not agree with minimum
tps voltage on DRBIII(1.80v). Unplugging MAP or reset min
tps will reduce setting to 1.00v, but eventually after
restarting or running vehicle valu... |
View |
|
1996 Dodge Pickup 5.9L Wheel Brg.
vehicle came in with brg very loose. In replacing hub
assemble found ujoint and upper and lower ball joints
needed replace. Put everything it needed new in and had
play in brg and found there is a spacer between the brg
assemble and dust shield. Part no. 05003... |
View |
|
2000 Dodge Dakota 4.7L Poor Idle Quality, Stall
Customer came in with vehicle complaint of truck stalling
when put into reverse. Spark plugs were bad, replaced,
clean IAC motor, helped but still would die, replace IAC,
Replace TPS, Recalibrated both reset all adaptive learning.
Cleaned throttle body 2 times... |
View |
|
1995 Eagle Talon 2.0L Cuts out, Stall, loses injector pulse
customer's car cuts out when hot or cold, all the time when
hot, on occasion when cold as soon as put in gear, spark is
strong and present, vehicle injector pulse dims then
disappears (noid light) was thinking trigger signal i.e.
crank cam sensor, but no lost ... |
View |
|
2000 Jeep Grand Cherokee 4.0L Misfire, MIL Lamp on
I have another jeep 4.0 that is giving me trouble, I really
hope someone can give me some help, I need it. This truck
came in with a p300 and p301. We quickly determined that
coil was not working on #1, so we put plugs(champions) and
a napa coil pack on. I let... Trouble codes: 300 (301 -), 301 (302 -), 302 (303 -), 303 (304 -), 304 (305 -), 305. |
View |
|
2004 Chrysler Town & Country 3.3L Surge, Cuts out, MIL Lamp on, P0016
AFTER REPLACEMENT OF CRANK AND CAM SENSORS FLEX PLATE AND TIMING CHAIN VEH. STILL OUT OF SYNCH. CHECK TRASNMISSION AND ENGINE IDENTIFICATION LABELS FOUND OUT ENGINE IS 2001 AND VEH. 2004 AND ENGINE MUST BE 2004 OR 05. THIS TOOK A LOT OF RESEARCH. CUSTOMER HAS... Trouble codes: P0016 (crankshaft timing), P0344 (cam sensor sigal intermittent). |
9 |
|
1994 Dodge Dakota 5.2L Rear brakes
Well must have been a stuck equalizer valve or something. Power Bled the brakes by pulling a vaccum thru them and viola brakes returned...Not sure why this would happen as i NEVER opened the system. O well Thanks to everyone again. |
11 |
|
1995 Dodge Pickup 5.9L No Start
well Guys Like I had said before I had checked all my rubber lines ect... I put some fittings together to go into my supply line of the injection pump and tested the pressure i had good pressure to Injection pump when It wouldnt start right off no wait to buil... |
9 |
|
2000 Dodge Dakota 4.7L Delayed engagement
Well the pcm was causing a communication problem between the pcm and tcm but was not the delayed engagement problem. The fluid was leaking thru the power steering pressure switch and leaching up the wire to the pcm and filled it with power steering fluid. The ... |
4 |
|
1998 Jeep Grand Cherokee 4.0L No Start, Stall
Hello, Thank you for all who gave information. I have finoly tracked the problem down to the 5 volt ref on the cam sensor. Intermitantly the voltage whould stay at 5 volts. after tracing the wireing down and waiting for it to happen again I found that the ECM ... Trouble codes: p0351 (ign primary 1 circut). |
10 |
|
2000 Jeep Grand Cherokee 4.0L pcm
Thanks to all the tech's that offered help. Most were procedures that I already tried. One sugestion was the Bulkhread connectors & the connector behind the passenger kick pannel. These checked out OK. Another tech suggested I dis-connect the clockspring at th... |
9 |
|
Prev
