|
|
1992 Chrysler Town & Country 3.3L Tire Pressure Monitoring
Tire pressure monitoring shows various tires with low
pressure. Some times it is one, other times two and
sometimes all four. We have checked the tires with an
accurate gauge many times. We have reset all of the wheel
sensors with the magnet as supplied by Chr... |
View |
|
1993 Chrysler New Yorker 3.3L Misfire
Car came from another shop. Found little to no spark on
cylinder #1 & #4. When we had spark it was 1\32 only. I
scoped the cam and crank sensors and all was good and in
sync. I then scoped the signal from the coil driver's (all
3) in the ECM. All three were go... |
View |
|
1999 Chrysler Sebring 2.5L Cuts out
this one is major head scratcher, it runs great 99% of the
time, but every 10 miles or so it just shuts off for maybe
10 seconds like the key was turned off or sometimes will
shut off and then wont start for 5 minutes. there are no
codes and i cant seem to cap... |
View |
|
1999 Chrysler Town & Country 3.8L Battery Light
Van came in throwing code P1478- battery temp sensor out of
range. After going over the diagrams I was unable to find
any sign of a temp sensor. Took battery tray apart and
checked the area of the the battery and could not find the
sensor. After doing more res... |
View |
|
2002 Chrysler Sebring 2.4L Poor Idle Quality, Cuts out, MIL Lamp on
I just took over on this project, the previous technician
installed an alternator and repaired the rear o2 sensor
wiring. The wires for the rear o2 were severed just before
the connector on the harness side, it was soldered and heat
shrinked. The car had codes... Trouble codes: P0132 (Upstream O211 shorted to voltage), P0118 (ECT sens voltage too high), P1492 (Bat Temp Sensor Voltage to high), P0325 (Knock sensor circuit volts to low), P0138 (Dpwmstream O2s 12 shorthigh). |
View |
|
1996 Dodge Dakota 2.5L No Start
no start - no communication from pcm, went to no start no
communication on alldata, did pin out test for powers and
ground to pcm,had 3 power sources off the ignition switch
and checked the 2 grounds-black wire and tan tracer, it
checked good.replaced the pcm ... |
View |
|
1996 Dodge Neon 2.0L Poor Idle Quality, Misfire, MIL Lamp on
had this car here in the past well maintained when the ses
light comes on i get a call immediately scanned it showed
misfire on #4 cylinder another shop diagnosed and said it
had no compression on that cylinder we also comped it and
we had 30 lbs dry and 80 wh... Trouble codes: 401 (4 misfire). |
View |
|
2000 Dodge Pickup 5.9L No Start
this truck will start normal /then intermittenly not
start/when cranking scan data shows normal/no codes/lift
boost pump was changed at an other shop/wouldn't start/we
bled fuel system /started ok/found air in system/started ok
for days/then same problem/long ... |
View |
|
2000 Dodge Dakota 4.7L Poor Idle Quality, Stall
Customer came in with vehicle complaint of truck stalling
when put into reverse. Spark plugs were bad, replaced,
clean IAC motor, helped but still would die, replace IAC,
Replace TPS, Recalibrated both reset all adaptive learning.
Cleaned throttle body 2 times... |
View |
|
2004 Dodge Pickup 5.7L Hesitation
Good day people. I have this 04 Dodge Ram with a hemi
engine that was cutting out with a no start condition then
the electronic throttle control light would come on. If it
did start there would be no throttle control. Codes
indicated possible 5 volt referance ... Trouble codes: P0652 (auxiliary 5 volt supply low), P2127 (APP 2 low), P2138 (APP 1 and 2 voltage performance), P0340 (Camshaft position sensor circuit), P0344 (Camshaft position sensor circuit intermittent). |
View |
|
1998 Jeep Wrangler 4.0L Misfire
thanks to all who read this. we have this vehicle which is
new to the customer and it only misses at cruise and warm.
the miss cannot be felt when driving but shows on the
misfire moniters on the modis and of course sets codes. we
have checked ignition parts, ... Trouble codes: P0300 (random misfire), P0301 (cyl 1 misfire), P0303 (cyl 3 misfire), P0304 (cyl 4 misfire), P0305 (cyl 5 misfire), P0306 (cyl 5 misfire). |
View |
|
1998 Chrysler Concorde 3.2L Failsafe mode/trans
Thanks for all the info guys have done most of it with out success.Waiting for cust to bring back car,he is on tight schedule will try to repair and notify when done thanks again Darren. |
9 |
|
1996 Dodge Pickup 5.9L Wheel Brg.
Hi guys and gals, Thank you for your response. It was a brg issue. The inner hub was machined deeper than the 2nd brg assembly we got you could see the difference when you put them side by side. I did not go out there and look the situation over until I waited... |
6 |
|
2002 Dodge Caravan 3.3L Blower,wipers,radio
Good morning gentlemen.I believe the problem with this vehicle is in the bulkhead connector or wiring. After trying a used IPM and relay box thought I had the problem fixed but after awhile it returned (in a different form again).After watching the voltage on ... |
5 |
|
2007 Dodge Pickup 5.9L daytime running
Thanks to all who responded to my request.Everyone nailed it .It was a matter of reprogramming tipm to can code.Other dealer in town did job no problem.Once again thank you. |
10 |
|
1997 Jeep Grand Cherokee 5.2L cruise,horn
Wow,overwhelming concensus on a faulty clockspring,but it was the harness about 2 inches from the clockspring connector that was the culprit here-all 6 wires broken right off.Thanks so much for the helpful information.iAtn rocks. |
14 |
|
1999 Jeep Wrangler 4.0L Misfire
Thanks to each of you that replied. After discussing the possibilities with the customer, he decided not to pursue this problem. I think the problem is caused by valves sticking. I did give the customer a couple of cans of good injector and top end cleaner. H... |
4 |
|
Prev
