 Prev |
Professional Automotive Repair Technical Discussions for May 16, 2016 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 2004 Honda Accord EX 3.0L MIL Lamp on VIN: 1HGCM81664 Working on a 2004 Accord 3.0 manuel trans. setting code p1077. Stepper motor is only driven in 1 direction by pcm. Can unlug pcm and drive motor either way. I am assuming imrc position is controlled by reversing polarity at motor. But when looking at wiring di... Trouble codes: P1077 (IMRC stuck stuck short), P1088 |
View | |
| 2008 Honda Civic EX 1.8L compressor VIN: 1HGFA16838 This car came in with the compressor cycling rather rapidly. The info I got was not cooling well. So this made since. I evacuated and recharged. The next week it was back, this time the compressor was not coming on. We found the clutch was open so we replaced ... |
View | |
| 2008 Honda Civic EX 1.8L Starting VIN: 2HGFG11898 Replaced engine with a low mileage engine. Engine will only start if a scanner is plugged in dlc. Doesn't matter if it is small reader or a Snap On scanner. If you un-plug the scanner the engine shuts off. Thanks for help. al |
View | |
| 2006 Hyundai Tucson GL 2.0L Powersteering Pump VIN: KM8JM12B96 We replaced the timing belt and accessory belts on this Tucson and have had nothing but grief with the steering since. We disconnected the hose from the power steering reservoir to the pump during the job. When we initially refilled the system we did not follo... |
View | |
| 2008 Isuzu i-290 S 2.9L no compression VIN: 1GGCS19998 timing chain broke after replacement of all timing parts engine just free spins pulled pan and confirmed chain intact and crank spinning found no oil pressure (no oil in VVT solenoid) also replaced.replaced oil pump and cover no change I did check timing 3 tim... |
View | |
| 2002 Kia Optima SE 2.7L Hesitation, MIL Lamp on, Poor Performance VIN: KNAGD12842 We have this Kia that came in with MIL on and a complaint of sluggish acceleration. From a stop the car with hesitate and accelerate very slowly then suddenly just kick in and accelerate good. Monitored the O2 sensors. Bank 1 is fluctuating between very low ... Trouble codes: P1167 |
View | |
| 2007 Lexus IS350 3.5L No Start VIN: JTHBE26257 Hey all thank you for your time, am helping a shop near me , we trade favors etc. As explained to me, after overheat motor pulled and disassembled. Bores and deck were fine, heads pressure tested and rebuilt. engine reassembled during removal, one injector was... |
View | |
| 2006 Toyota RAV4 Sport 2.4L engine VIN: JTMBD32VX6 Good Morning fellow wrenches. We have to replace the engine. Shop Key says to remove motor and trans together. Was wondering if anyone has tried to just pull the motor.Looks a little tight, but might work if the balancer and maybe a few other pieces are remove... |
View | |
| 2008 Toyota Tundra SR5 5.7L No Start VIN: 5TFRV541X8 Hi techs. This is an 2008 Toyota Tundra V8 5.7L. Truck crank but no start, no fuel pressure, ignition good. I check all 3 EFI, Fuel pump and C/Onp( circuit opening) relays are all good. Key on signal does send power to fuel pump control ECU. Fuel pump ECU has ... |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 2006 Acura MDX Touring 3.5L Misfire, MIL Lamp on VIN: 2HNYD18876 Thanks for all the replies. Most suggested items we had already done. I also spoke to Wayne at Identifix, he says that the misfire diagnostics on these cars are not reliable, and the -14 fuel trim might indicate a leaking injector, as I thought. I did check th... Trouble codes: P0301 (p0302-), P0302 (p0303-), P0303 (p0304-), P0304 (p0305-), P0305 (p0306-), P0306 (testing and results). |
22 | |
| 2005 Toyota Sienna XLE 3.3L all power acc. and lights VIN: 5TDZA22C15 first of all thank you guys for the help and the information on this repair the problem ended up being a relay under the dash that powers up the fuse box from the ignition switch replaced the relay an all is back to normal. thanks for all the help |
8 |
