|Prev||Professional Automotive Repair Technical Discussions for October 3, 2014
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for GM
|2002 GMC Sierra 2500 HD SL 6.6L No Start VIN: 1GTHK23172
gentlemen, this is a shout out to all my diesel techs out there, im not one for asking for help , i almost always have to help and re sources to fix all my vehicles but my diesel experience is limited, the truck came in with a u 1000 , p0380, hard start condit... Trouble codes: U1800, P0380
|2005 GMC Sierra 2500 HD SLE 6.6L No Start VIN: 1GTHK23285
Hello iATN Techs, This diesel truck runs normal and is not setting any codes. After a heat soak it will crank and not start. If I cycle the fuel primer on the filter housing the truck will then start. If the vehicle sits over night after a no start, it will st...
|1996 Pontiac Grand Am SE 2.4L speedometer VIN: 1G2NE52T1T
speedo inop after going 3 miles per hour checked green with white tracer wire going from cluster to ecm replaced ecm and replaced cluster. I also checked all grounds and replaced vss. The vehicle speed reads ok in ecm but in cluster data it drops out also. The...
|2008 Pontiac Torrent 3.4L washer pump VIN: 2CKDL33F18
Greetings and thanks to all in advance. Have no washer oper. front or rear . Fuse is good, scan tool shows washer commands present when requested. Question, where are the washer relays. Alldata says they are in the power dist. center. Washers will run when pow...
Fixes & Summaries for GM