
![]() |
Professional Automotive Repair Technical Discussions for April 25, 2014 International Automotive Technicians' Network (iATN) - Members Only |
Next ![]() |
(Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. |
Open Help Requests for Chrysler
Help Request | Answers | |
1994 Chrysler LHS 3.5L Ignition VIN: 2C3ED56F4R Car was towed to the shop and it was one our regular's chrysler Lhs . Customer complained that while driving the car suddenly shut down . He pulled over , tried to start the car, started for a short time the shutoff and this it would not start. Since its obd1 ... |
View | |
2007 Chrysler Pacifica Touring 4.0L Stall VIN: 2A8GF68X37 Customer brought car in a week ago stating it died while driving. she said it started back up and just wanted us to take a quick look. check for faults in ecm and tcm-no faults. test drove-cold not duplicate concern. checked on internet for similiar complaints... |
View | |
1997 Dodge Dakota 3.9L No start/shut down VIN: 1B7GL23X2V Truck was brought to me for intermittent cut off/no start condition. Found bad water pump and blown head gasket on right bank. Repaired these and installed a new ECT. Truck ran fine for a a couple of days, cut off on owner. I replaced the sync sensor which app... |
View | |
2004 Dodge Durango Limited 5.7L No Start VIN: 1D4HB58D04 Engine starts cold no problem. When hot will not start normally, but if you barely push down on gas pedal it will start every time |
View | |
2008 Jeep Grand Cherokee Laredo 3.0L ecm VIN: 1J8HR48M48 once ecm was replaced we had a skim code and no start. can not program vin with snap on verus. my iflash is down so I had truck towed to dealer. they tell me they can not reprogram a used ecm to this truck. any one have any experience with this? |
View |
Fixes & Summaries for Chrysler
Fix/Summary | Answers | |
1999 Dodge Durango SLT 5.2L trans temp VIN: 1B4HS28Y0X i found an open in the harness at the bulkhead repaired that and found more issues at the connector going into the transmission so i replaced the connector and all is good thanks for your help guys |
5 |