Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for November 22, 2013
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
2000 Ford Windstar LX 3.8L speedometer VIN: 2FMZA5141Y
I am workingh on this windstar thatthe speedometer is running half speed it has a new speedo head the vss signal to computor is corect also has 2 antilock codes left front wheel speed sensor missing right rear wheel speed sensor missing ,talked to local Ford g...
2003 Ford F-550 Super Duty XL 6.0L No Start VIN: 1FDAW57P63
This is my tow truck and daily driver. The last couple mornings it runs real rough until it warms up then runs great. Now it will not start. Scan data says no sync,if cranked for a long time it sets a cam sensor code. I ohm tested the wires to cam and crank an...
2004 Ford E-350 Super Duty 6.0L Stall VIN: 1FDWE35P24
This box truck came in on a hook from another shop so we cant be sure of all attempted repairs.Engine runs fine until it starts to warm up then dies like you shut the key off.The engine does not surge or stutter & always restarts once the key is shut off.This ...
2005 Ford F-250 Super Duty King Ranch 6.0L No Start VIN: 1FTSW21P45
Thanks in advance for any help, this vehicle had a blown head gasket, we put new head gaskets, ipr was broken so replaced that, but the vehicle does not starts, all the readings seems good, any help would be appreciated. Thanks. Trouble codes: P0261, P0267
2005 Mercury Mariner Premier 3.0L parking brake light VIN: 4M2CU56165
the vehicle came in with major oil leak, no electrical problems at all, put the vehicle on the lift replaced oil pan gasket, when i set the vehicle back down, had no power windows, no radio, no power door locks and the parking brake light is on with a message ...

Fixes & Summaries for Ford
Fix/Summary Answers
1996 Ford F-350 Eddie Bauer 7.3L No Start VIN: 1FTHF36F4T
Thanks again to all who replied. The short story is the wrong Cam Sensor caused our grief. This is the long part. Sorry I forgot to post the oil pressure specs initially. They were fine. 500 PSI imediately & up to 3000 Psi after cranking a bit. Verifie...
1998 Ford Ranger Splash 3.0L Misfire VIN: 1FTYR14U7W
Thanks for all the replies. This one is still puzzleing me. First of all, the machine shop I used does very good work. The heads came back looking brand new. No grease or oil of any kind on it. The intake manifold I cleaned and was completely dry when I put it... Trouble codes: P0305.
1999 Ford Windstar SE 3.8L All VIN: 2FMDA5247X
Thanks guys, the fix was replace the front and rear electronic module. We found out the rear module been replace about 3 months ago for some lighting issues. I can't explain why both were bad at the same time. It was a used part, maybe it was bad in the first ...
2006 Ford Explorer Eddie Bauer 4.0L Bearing noise VIN: 1FMEU74E46
We ordered the chassis ear. I was floored, all that noise and steering wheel vibration that sounded like it was from the left front was from the right rear bearing. I hate ford bearings. We have another explorer in the shop for a similar issue. At least I have...
2007 Ford Five Hundred Limited 3.0L ac blower VIN: 1FAHP25147
replaced blower motor resistor & control panell. both were bad. thanks to all who replied.
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next