× Auto Repair Pros Member Benefits TechHelp Knowledge Base Forums Resources My iATN Marketplace Chat Pricing About Us Join Industry Sponsors Video Members Only Repair Shops Auto Pro Careers Auto Pro Reviews
Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for May 8, 2013
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2003 Chrysler Sebring LX 2.4L transmission VIN: 1C3EL46X63
Customer came in with leaking TCM on side of transmission...erratic shifting and P0700 stored in ECM. Quart low on fluid, replaced TCM, customer returned 4 days later...did not act up for us, but code was stored for P0700 and transmission stored P0888 for rela...
2007 Chrysler Town & Country LX 3.3L 2-3 shift VIN: 2A4GP44R47
As stated the transmission was replaced due to reverse being out but the 2-3 shift when cold does not happen. On the lab scope pins 7&8 get a pulsed signal during 1st gear, no pins are grounded for 2nd gear, and when cold only pin 6 gets the ground pulse and n...
1998 Dodge Ram 1500 ST 3.9L No Start VIN: 1B7HC16X7W
Customer was driving vehicle, vehicle stalled. Customer thought alternator was bad, so he installed reman. alt. and new battery. For whatever reason, he disconnected the alternator feed wire from underhood fuse box and the negative body ground wire from negati... Trouble codes: P1389
1999 Dodge Ram 2500 5.9L No Start VIN: 3B7KF2364X
Customer states vehicle runs fine once started no performance issues . Just intermittently it will experience a hard start / long crank time condition . When symptoms occur , if you cycle the key it usually starts right up . Narrowed down condition to fuel rel...
2006 Dodge Ram 2500 SLT 5.9L a/c componants VIN: 3D7KR28CX6
This thing is back for the same reason. rechecked for leaks at compressor, hoses and fittings, accumulator, service ports, and evap. Checked for any TSB for unusual leaks--none found. I have also had a 2008 Dodge with same engine and same complaint. Anyone els...
2008 Dodge Caliber R/T 2.4L Trans overheating VIN: 1B3HB78K88
Customer drives car around 75 to 100 miles (freeway) and the Trans/overheat light comes on at dash. The vehicle reduces speed and customer has to wait 20 minutes and good to go again. I have scanned and monitored trans temp, the hottest I get is 186 degrees an...
2009 Dodge Journey SXT 3.5L MIL Lamp on VIN: 3D4GG57V29
This car intermittently sets a P1004, Short Runner Valve Control Performance code. I have done the actuator test through the scan tool and it won't set the code in the bay. I have done a search and all that I've found is an unclosed help request where the resp...

Fixes & Summaries for Chrysler
Fix/Summary Answers
2006 Chrysler PT Cruiser Touring 2.4L Ignition switch VIN: 3A4FY58B06
Sorry for the late posting,lady brought car back in,I checked battery connections,grounds to body & engine.So really I just installed new ignition switch & checked the above,Have not heard back from her.Had alot of replies,most said to check connections to ba...
2000 Dodge Dakota 4.7L current draw VIN: 1B7GG22N2Y
Performed the current draw test several times, letting the vehicle set for up to an hour after removing the key and shutting the doors. 2 of those times the draw did not drop to normal(37 ma) but stayed over 100 ma. Replaced the trans relay and repeated the ...
2001 Jeep Cherokee Classic 4.0L No Start VIN: 1J4FF58S31
Vehicle speed sensor was shorted to ground. replaced and all is good. thanks for the help.
2002 Jeep Liberty Limited 3.7L No Start VIN: 1J4GL58K92
Thanks for all of the help. We pulled the timing cover off and found the Key-way on the crank pulley sheared. The pulley was wedged and spinning the cams, but off time.
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next