 Prev |
Professional Automotive Repair Technical Discussions for May 9, 2013 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2001 Chrysler Town & Country EX 3.8L Stall VIN: 2C4GP54L91 Came in with low map voltage and stall bad even in park or any gear. Smoke tested and checked fuel pressure. Found leaks all over egr and throttle body filthy. Also checked compression and was 125. Then closed off egr and done intake and injection cleaning wit... Trouble codes: P0107 |
View | |
| 2005 Chrysler 300 C 5.7L Mil on VIN: 2C3JA63H35 Vehicle runs perfect but Mil comes on right away whit code P0016 Crank/Cam Misalignment -bank 1 Sensor 1, Scanner Data is Cam/Crank difference -10 deg. we scope sheck the sensors to me they look ok, we also moved cam & crank sensor connectors by looking at the... |
View | |
| 2007 Chrysler PT Cruiser 2.4L compressor clutch VIN: 3A4FY48B07 Withdrew and recharged system to spec (was a little low. Test continuity of low pressure switch as bad then jumpered it. Tested high pressure as electronically good then jumpered it as well because lock was broken.Clutch still inoperative. Placed headlight on ... |
View | |
| 1996 Dodge Ram 2500 5.9L Torque Convertor VIN: 1B7KC23C1T Customer states that when cruising 50 mph or more, and letting off the accelerator pedal, the truck will bump/buck hard once, each time he does it. We've driven the truck, and confirmed the feeling. Using a verus scanner, you can watch that you are in 4th, the... |
View | |
| 2006 Dodge Durango SLT 3.7L MIL Lamp on VIN: 1D4HD48KX6 Hi all, thanks for any help you can give me. This durango came in with a PO456 small evap leak code. I put the smoke machine to the system, I have a MODIS that I hooked to the truck and under 'bi-directional controls' I closed the NVLD solenoid to seal the sys... Trouble codes: P0456 |
View | |
| 2002 Jeep Grand Cherokee Laredo 4.0L gauges VIN: 1J4GW48SX2 Hi, I have a 2002 jeep grand cherokee 4.0. The vehicle starts and runs, security light is on, gauges do not work, power windows/locks inop. intermittently. pcm code p1687. Disconnecting battery will make power windows/locks come back but gauges stay dead. ECM ... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2009 Dodge Journey SXT 3.5L MIL Lamp on VIN: 3D4GG57V29 Well, this car has went down the road. The sticker isn't up until the end of next month so they decided that it wasn't critical yet. They called the dealer and were told that they were having a few problems with manifolds and if they brought it in they would c... |
6 | |
| 2010 Dodge Avenger SXT 2.4L No Start VIN: 1B3CC4FB0A I went ahead and ordered the TIPM from the dealer and installed it. That did indeed fix the problem.The starter activated and started the car. Thanks for all the good information I received. |
9 | |
| 1996 Jeep Grand Cherokee Laredo 5.2L Starting VIN: 1J4GZ58Y8T Short answer, an IPC fixed it. Here is what we ended up doing: we sent the BCM in to have it tested, and it was good, they returned it to us, we re-installed it and after that the system worked properly, with no draw, for about 3 hours and then started acti... |
9 | |
| 2004 Jeep Liberty Renegade 3.7L Poor Idle Quality, MIL Lamp on This has passed all monitors and passed emissions now for more than a week and half so I will call it fixed. After fixing harness issues supplying the 3 volts on signal wire light went out. Its a good idea to check signal wire voltage and make sure below .7 vo... Trouble codes: P0123, P0156. |
6 | |
| 2012 Jeep Wrangler Unlimited Sport 3.6L Cooling Systems VIN: 1C4BJWDG7C I have not got this truck fixed yet but as suggested,if the engine got that hot that it melted the plastic oil filter housing under the intake,than more than likely there must be other damage..I found out the hard way..I replaced the oil flter housing & when I... |
3 |
