|Prev||Professional Automotive Repair Technical Discussions for January 26, 2013
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|2002 Ford F-350 Super Duty XL 7.3L Cuts out, Stall VIN: 1FDSF34F52
Stalls hot or cold at idle when blowing the horn or activating the washer pump for the wipers. Checked/cleaned all grounds and ran multiple new grounds. Battery negative to battery negative, battery to body, body to washer pump- right front headlight/park/turn...
|2005 Ford Escape XLT 3.0L Poor Idle Quality, Misfire, MIL Lamp on VIN: 1FMYU03185
Hard misfire #5 have move coils around,ohm wires to PCM,pulled valve cover looked at cams,valve springs ect.,check for vacuum leaks,run compression test. I'm thinking internal vacuum leak ,have smoked ,no leaks found .well maintained ,engine clean inside. Trouble codes: P0174 (Lean bank2), P0305 (Misfire cylinder 5), P0316 (Misfire first 1000 rpms)
|2009 Ford Flex SE 3.5L Brake pedal VIN: 2FMDK51C29
I have a 2009 Ford Flex with a strange brake problem. The customer brought this vehicle in because of a spongy brake pedal. He says that it only has been this way for about 3 months. He has owned the vehicle since it was new. We were able to duplicate the conc...
Fixes & Summaries for Ford
|2003 Ford F-250 Super Duty XLT 6.0L f2-22 VIN: 1FTNX21P93
Hey guys, this is what I came up with. Installed fuses on each leg of f2-22 to isolate circuit and road tested vechicle and imagine that truck would run fine, decided that when installing fuses that harness moved enough that chaffed wire was relocated but this...
|2004 Ford F-150 FX4 5.4L Mechanical VIN: 1FTRF14524
thanks for all the help. The camshaft timing was the problem, the bank 1 camshaft chain had jumped, the tensioner was in about a dozen pieces! I can't believe more didn't break, the timing chain, tensioners,and the cam phasers have been replaced. runs fine! be...