Join Now
International Automotive Technicians Network

P0316 Diagnostic Trouble Code Discussion for January 2013

Misfire Detected On Startup (Within the 1st 1000 Revolutions)


Note: This is a professional automotive technician's resource.
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Trouble Ticket Help Requests for DTC P0316
Help Request Posted
2011 Ford Ranger XL 2.3L Poor Idle Quality, Misfire VIN: 1FTKR1ED7B
P0316: Missfire Detected On Startup. This vehicle was brought in and was running fine. Driver said check engine light was on and would barely run. Retrieved codes listed below and performed pinpoint test KG for the DTC P0210. Unable to find any failed test and we drove car for a week with no conc...
January 10, 2013
2006 Ford Expedition XLT 5.4L Misfire VIN: 1FMPU16516
P0316: Engine misfire on startup. This vehicle is a Police Patrol unit. It has a misfire under load on cylinder #03. The engine runs smoothly at idle and seems ok at all speeds until you floor the accelerator pedal. It starts out ok but in a second or two it starts to misfire horribly and it s...
January 14, 2013
2002 Ford Windstar SE 3.8L Poor Idle Quality, Misfire VIN: 2FMZA574X2
P0316: Missfire detected at start up. This vehicle came in with a serious miss and the cust concern was would it leave him stranded. With the scan tool we retrived two codes related to the missfire, 302 and 316. We replaced the spark plugs because they looked so bad and paying special attention to...
January 22, 2013
2002 Ford Ranger Edge 3.0L Poor Idle Quality, Misfire, MIL Lamp on VIN: 1FTYR10U12
P0316: engine fire on start up. Customer brought the vehicle in complaining of a misfire in reverse and CEL was on.This truck had a tuneup about 6 months ago at another shop and plugs and wires are motorcraft. test drove and the misfire is there all the time.Pulled codes and found P301 and P...
January 24, 2013
2005 Ford Escape XLT 3.0L Poor Idle Quality, Misfire, MIL Lamp on VIN: 1FMYU03185
P0316: Misfire Occurred In First 1,000 Revolutions. Hard misfire #5 have move coils around,ohm wires to PCM,pulled valve cover looked at cams,valve springs ect.,check for vacuum leaks,run compression test. I'm thinking internal vacuum leak ,have smoked ,no leaks found .well maintained ,engine clean inside.
January 26, 2013
2011 Ford Ranger XL 2.3L Poor Idle Quality, Misfire VIN: 1FTKR1ED7B
P0316: Missfire Detected On Startup. This vehicle was brought in and was running fine. Driver said check engine light was on and would barely run. Retrieved codes listed below and performed pinpoint test KG for the DTC P0210. Unable to find any failed test and we drove car for a week with no conc...
January 10, 2013
2006 Ford Expedition XLT 5.4L Misfire VIN: 1FMPU16516
P0316: Engine misfire on startup. This vehicle is a Police Patrol unit. It has a misfire under load on cylinder #03. The engine runs smoothly at idle and seems ok at all speeds until you floor the accelerator pedal. It starts out ok but in a second or two it starts to misfire horribly and it s...
January 14, 2013
2002 Ford Windstar SE 3.8L Poor Idle Quality, Misfire VIN: 2FMZA574X2
P0316: Missfire detected at start up. This vehicle came in with a serious miss and the cust concern was would it leave him stranded. With the scan tool we retrived two codes related to the missfire, 302 and 316. We replaced the spark plugs because they looked so bad and paying special attention to...
January 22, 2013
2002 Ford Ranger Edge 3.0L Poor Idle Quality, Misfire, MIL Lamp on VIN: 1FTYR10U12
P0316: engine fire on start up. Customer brought the vehicle in complaining of a misfire in reverse and CEL was on.This truck had a tuneup about 6 months ago at another shop and plugs and wires are motorcraft. test drove and the misfire is there all the time.Pulled codes and found P301 and P...
January 24, 2013
2005 Ford Escape XLT 3.0L Poor Idle Quality, Misfire, MIL Lamp on VIN: 1FMYU03185
P0316: Misfire Occurred In First 1,000 Revolutions. Hard misfire #5 have move coils around,ohm wires to PCM,pulled valve cover looked at cams,valve springs ect.,check for vacuum leaks,run compression test. I'm thinking internal vacuum leak ,have smoked ,no leaks found .well maintained ,engine clean inside.
January 26, 2013