|Prev||Professional Automotive Repair Technical Discussions for May 11, 2012
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|1992 Ford E-150 Econoline XL 5.8L No Start VIN: 1FDEE14H3N
This only seems to happen when I work on a relatives vehicle. Van came in as a crank no start. Checked spark-no spark. Tested and found the coil was bad-shorted. Installed a new coil and it had no spark. Replaced the ignition module-had good hot spark. Engine ...
|1994 Ford E-350 Econoline 7.5L Poor Idle Quality, Surge, Cuts out, Stall VIN: 1FDKE30G2R
sputters idles up and down and cuts off can wait appx 20 minutes and veh will start back up has code 624 any help greatly appreciated Trouble codes: 624
|1997 Ford F-350 7.3L Mechanical VIN: 1FDKF37F2V
Hi every one, i have an ambulance that has a no start condition. I hooked up a suitable scanner, got communication but no codes as this being an ambulance it has a master power switch and some one had turned it off before i came so i suspect all codes if it ha...
|2005 Ford Five Hundred SEL 3.0L temp. blend door VIN: 1FAFP24125
customer complaint of cold air on drivers side, and no so cold air on passenger side air vents while a/c is in cold position. I removed the passenger air door motor, and manualy moved the door while car is runninjg with a/c on . Passenger side temp does change...
|2007 Ford F-250 Super Duty XLT 5.4L Poor Idle Quality, Misfire, MIL Lamp on VIN: 1FTSX205X7
truck cam in running rough all the time,found codes for cam over retared bank 2 and over advanced bank 1.replaced both phasers and timing components with oreilly parts,replaced left side cam soleniod from ford.now truck will run ok driving down the highway but... Trouble codes: P0022 (Cam over retarded bank 2), P0340, P0345, P0349
Fixes & Summaries for Ford
|1975 Ford Mustang II 5.0L tach VIN: 5F04F21862
thanks for the help. i had called msd first that is how i got the adaptor. i called back and asked for a diagram it got here about the same time i opened this help request.it is the red/lt green wire. after all the trouble i know why there is a aftermarket tac...
|1991 Ford F-350 Custom 7.5L Misfire VIN: 2FDJF37G0M
thanks for all your help, after haveing someone with a pressure transducer come over and scope the car, although it passed the noid light test, we found that the wire for the injector for cyl#1 was hanging on by a thread, we fixed the broken wire and i...
|1995 Ford Explorer Eddie Bauer 4.0L No Start VIN: 1FMDU34XXS
We ended up changing the fuel pump, filter, and relay Thanks everyone for the help Trouble codes: 542 (Fuel pump circuit open).
|1999 Ford Ranger XL 3.0L No Start VIN: 1FTYR14V1X
I want to thank everyone that gave the support with so many email replies,and yes most of you were right the computer is at fault, the ground signal is not generated,upon cranking or with key on engine off what I did is i ground the signal wire at the computer...
|2000 Ford F-150 Lariat 5.4L Engine VIN: 1FTRX17L7Y
Thanks for all the info, went with the first fix procedures that were recommended and were a first check before going any further, checked all resistance on ignition coils, all ok at this time checked resistance on all injectors ok at this time around 1.3 1.5 ...
|2000 Ford F-150 Lariat 5.4L rear brake lights VIN: 1FTRX17L7Y
Once i got wiring route of system thanks too all of you, i found power acually goes through the third bulb to complete circuit found bad buld replace bulb and a overheated looking socket and all is good at this time thank you all for your support
|2005 Ford F-150 FX4 5.4L Poor Idle Quality, Stall, MIL Lamp on VIN: 1FTPX14535
oil pressure was the issue. bandaided (iknow) with thicker oil and advised to get rid of vehicle. customer did not want to replace engine. Trouble codes: P0022 (Bank 2 cam retarded).
|2007 Ford F-350 Super Duty XLT 6.0L cooling system VIN: 1FTWX30P07
Thanks for all the great info,we ordered a tool online and removed all 8 injector cups (we couldnt see any visible holes in any cups)and installed 8 new cups and the problem was solved.Thanks again for the help