|Prev||Professional Automotive Repair Technical Discussions for February 26, 2012
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Asian
|1995 Isuzu Rodeo S 2.6L smog VIN: 4S2CG58EXS
this vehicle came in from another shop for failed NOX during the smog test. the EGR vale is not opening. the PCM will not command on the EGR solenoids to open the EGR valve. I can ground the solenoids seperatly and they both work. the ERG valve and the passage...
|1999 Isuzu Rodeo LS 3.2L Excessive Emissions VIN: 4S2CM58W0X
Back again yall. i have this 1999 isuzu rodeo 3.2 that is royally kicking my butt..failed California emissions and im attempting repairs. at 2500 all emissions are near zero. after holding 2500 rpm for 3-5 minutes it crawls down to about 15 for hc. co is 0 o2 ...
|2009 Nissan Altima S 2.5L Misfire VIN: 1N4AL24E09
Thank you for taking the time to read this and help out in advance. The problem we have is that the vehicle keeps seeting a p0303. I have moved the coils, plugs, and the injector to different cylinders. The misfire stays with cylinder 3. I have scoped the igin... Trouble codes: P0303 (Cylinder 3 misfire)
Fixes & Summaries for Asian
|2011 Honda Accord EX-L 2.4L Rear seat VIN: 1HGCP2F87B
I should have closed this earlier. The seat came out by perfect after releasing the 2 locks in the front and 1 bolt in the rear and the ring was found. Thanks to everyone that helped.
|2006 Kia Rio5 SX 1.6L engine VIN: KNADE16306
Lower down the frame with the engine and the transaxle. It's not difficult job. And without removing the front and the rear roll control mountings which hold the transaxle, replaced the engine. Thanks for Pros' helps again!
|1985 Nissan 720 2.4L Excessive Emissions VIN: JN6ND06S9F
I WANT TO THANK YOU GUYS FOR YOUR GREAT HELP, AND INDEED IT WAS THE MC SOLENOID , AGAIN IM GREATFULL
|2003 Nissan Maxima SE 3.5L Stall VIN: JN1DA31A33
I clean the throttle and after that the throttle plate was still sticking. I replace it, and fix the problem. Thanks everybody for the help.
|2005 Nissan Sentra 1.8L No Start VIN: JN1CFAN16Z
Thank you for all the reply's! George is on the money;- there is no way to get the QG18 started with a QG16 ECU,since the signals are way out. I tried inverting the CAM signal with a transistor to get the correct pattern,but if the signals are not in sinc -no ...