Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for February 26, 2012
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
1996 Ford E-350 Econoline XL 5.8L Surge, Cuts out VIN: 1FTJE34H0T
Ok, this Van is giving me fits. I have read about problems with the PSOM. The van came to me running very poor, jump buck, spark knock etc., After replacing the Pick up, ICM, and the Coil the van runs so much better, BUT I still have a Jerk or Cut out at highw... Trouble codes: 212 (during wiggle test)
2000 Ford Mustang 3.8L MIL Lamp on
getting codes for bank 1 sensor 1 and bank 2 sensor 1 heater circuit malfunction. customer already replaced both front oxygen sensors. I will check the vehicle this coming week and would like to know if maybe this is a common failure on this vehicles and you g...

Fixes & Summaries for Ford
Fix/Summary Answers
1994 Ford F-250 XL 7.5L Excessive Emissions VIN: 1FTHX26G9R
had to get CARB EO label so i could run vechile in pre test mode.once tested in pretest mode vehicle passed ca. emissions test.may have given some bad info. the readings at idle were actually at 15 mph.
2005 Ford F-150 FX4 5.4L MIL Lamp on VIN: 1FTPW145X5
I had bank two timing off by one tooth. When I first put it together I couldn't find the copper colored links. I thought I found them but must of been off. After further inspection I found the copper links and marked them better. This truck only had 47,000 ... Trouble codes: P0345 (Camshaft Position Sensor Circuit Malfunction Bank 2).
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next