|Prev||Professional Automotive Repair Technical Discussions for February 11, 2012
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2001 Chrysler Sebring LXi 2.7L f-end vibration
driver complant at 70 to 85 mph on freeway front end vibration as if tires re out of balance front end does have bushing noise but no sign of worn components we konw it needs shocks test drive vibration is not shock related.
|2003 Chrysler Town & Country (Van) Limited 3.8L Starting VIN: 2C8GP64L53
I have a 2003 t&c limmited in the shop. Unit starts and runs for about 3 seconds then shuts down. This is intermittent. I am aware of the the solder going open on the dash cluster and dont think this is the problem. The gauges work fine, when the unit shuts do...
|2005 Chrysler Town & Country (Van) Touring 3.8L engine VIN: 2C4GP54L65
could this be caused by a sticking pressure relief valve or some kind of restriction in the block. Thanks for your help here .
|2001 Dodge Durango SLT 4.7L Transfer case
Vehicle came in 4WD inop . Lights on switch do not come on at all. Can actuate 4WD by by-passing module. Checked all powers and grounds at module . No 5v reference on the 2 reference wires for switch and encoder motor.Module had internal failure code , Replace...
Fixes & Summaries for Chrysler
|2004 Chrysler Sebring LX 2.4L Ball joints- upper & lower VIN: 1C3EL46J84
We went ahead and replaced the entire arms, upper and lower, that had the ball joints already installed. That isn't much of a suspension system, and I guess the rest of the car is about the same!
|2000 Dodge Ram 2500 Truck 5.9L Shift Point VIN: 3B7KC2669Y
David from New York hit it on the head. The TV cable was binding because it was damaged before and I didn't see it. Replaced TV cable, adjusted it, and it shifts perfectly. Thanks to all of the techs in iATN land!
|2007 Dodge Charger 2.7L Unsure VIN: 2B3KA43R07
I would like to thank to all who replied. IATN is great! It turned out that the new right front wheel bearing was bad. The torque specs were 152 ft/lbs, but this one was tightened well over that. Not sure if that is what caused the damage or not, but I replace...
|2006 Jeep Commander (Truck) 4.7L Stall VIN: 1J8HG48N36
Thanks everyone, I ended up throwing parts at this thing until it was fixed. The customer and I decided that guessing at parts was cheaper than an $80hr labor rate attempting to diagnose an intermitent problem. We replace the EGR and the CKP and no change. We...