|Prev||Professional Automotive Repair Technical Discussions for July 16, 2011
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2008 Chrysler Town & Country (Van) Touring 3.8L Starting VIN: 2A8HR64X58
This van has been back to the dealer for intermittent starting many, many times. Customer states that randomly when you go to start it, you get a click and then nothing. Engine does not turn over. Nothing electrical. Wait a couple of minute, or hours, or overn...
|2000 Dodge Intrepid 2.7L No Start VIN: 2B3HD46R6Y
This is my wife's car and this morning it just quit on her. I scanned it, found the code for cmp/crnk sensor and was getting no sync signal. Unplugged the cam sensor and the car started up so we drove it home. I've tested the wiring between the cam sensor and ... Trouble codes: P1391 (Loss of CMP and/or CRNK Signal)
|2003 Dodge Ram 2500 Truck 5.9L control VIN: 3D7KU28C04
Any speed I can hit a bump in the road and the steering goes out of control until I stand on the brake to slow almost to a stop. Has someone in the world found a cure for this?
|1996 Eagle Talon 2.0L Excessive Emissions, Monitors reset VIN: 4E3AK44Y2T
Vehicle Came in for Rejection at state test lane. O2, O2 Heater, Cat, Egr, and Evap. Monitors wont set. No codes were stored. Scope Checked O2 Sensor and was very slow at responding to propane. Replaced Upstream O2 sensor and was now able to set all monitors b...
Fixes & Summaries for Chrysler
|1998 Dodge Ram 1500 Truck 5.9L Poor Idle Quality VIN: 1B7HC16ZXW
the problem was the upstream o2 sensor . I was looking for vacuum leak problem as was some of the replies.Others pointed to o2 sensors. Bruce suggested to unplug 02 sensor and run it to see if it acted up . It did not act up,replaced the sensor. Thanks to ever...