|Prev||Professional Automotive Repair Technical Discussions for July 16, 2011
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Asian
|1997 Kia Sephia LS 1.8L head gasket VIN: KNAFA1250V
Car came in with lots of white smoke, bad miss fire, very clean #1 piston, obvious head gasket failure. Replaced head gasket, started up and smoked just as bad. After warm up improved, on test drive ran great. Customer called next day, was missing again and lo...
|2001 Nissan Sentra SE 2.0L Poor Idle Quality, Hesitation, Stall, Misfire VIN: 3N1BB51D91
Good day all, Vehicle came in with rough idle at cold start and sluggish feeling when acclerating. Engine light was not on but scanned for codes anyways - P0300 and P0171. Did not find any misfires and system is not running lean. Tried replacing front o2 sen... Trouble codes: P0300 (Multiple Cylinder Misfire), P0171 (Lean)
Fixes & Summaries for Asian
|1999 Honda Accord EX 2.3L Stall VIN: 1HGCD715XR
most are suggesting that the ign switch will end up being the cause but just have not been able to condem anything believe we will replace switch and see if continues for customer or if fixes the problem
|2003 Honda Pilot EX 3.5L A/C compressor clutch and condenser fan relays VIN: 2HKYF18563
Thank you to everyone who replied to my request for help. A new Climate Control Unit fixed this one. I wasn't sure if a blank screen on entering self diagnostics indicated a problem with the controller or was normal for no codes--it is normal for no codes. Jo...
|2001 Nissan Maxima GLE 3.0L no shift VIN: JN1CA31D81
Thanks for all the suggestions, I ended up having the instrument panel checked and then rebuilt, it seems to have cured the problem.
|1994 Toyota Pickup DLX 2.4L Excessive Emissions, Poor Idle Quality VIN: JT4RW13P6R
Hello! We got this toyota fixed! After reading your replys, went ahead and missed with the adjustment screw 1/2 turn on the air flow meter and watched co and hc readings, they came down but not enough to pass are emission standerds. We decided to pull off the ...