|Prev||Professional Automotive Repair Technical Discussions for July 15, 2011
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1998 Chrysler Concorde LX 3.2L No Start, Cuts out, Stall VIN: 2C3HD46J5W
Well! the car came in with an intermitant stall and restart after it cooled down. When i finally got it to ack up the asd relay continue to click very fast even with the key out of the ignition. The starter relay and fuel pump relay would also click the same w...
|2004 Chrysler PT Cruiser 2.4L Hesitation, Surge, Cuts out, MIL Lamp on VIN: 3C4FY48B94
Need some help with an intermittent problem. Car came in with a P0344 and a P0340 Code we inspected the wires and and the sensor for any damage there was none to be found and the circuit tested fine with a multimeter. We replaced the Cam Sensor with knock off ... Trouble codes: P0344
|2003 Dodge Ram 2500 Truck 5.9L control VIN: 3D7KU28C04
Any speed I can hit a bump in the road and the steering goes out of control until I stand on the brake to slow almost to a stop. Has someone in the world found a cure for this?
|2004 Jeep Liberty Limited 3.7L MIL Lamp on VIN: 1J4GL5874W
cannot seem to nail this one down ...found faulty nvld first time around and cockily called it fixed even though i wasnt able to run evap monitor. admittedly threw a gas cap at it on 5:00 on friday when cust showed up with mil on again and hoped for the best.i... Trouble codes: P0440, P0456
Fixes & Summaries for Chrysler
|2001 Chrysler Town & Country (Van) Limited 3.8L Misfire VIN: 2C8GP64L61
The customer is not willing to spend any more money on this car. He had it at the dealer before it came to us and I think he is going to get rid of the car.
|2004 Chrysler Pacifica 3.5L Starting VIN: 2C46M684X4
Gentlemen After posting the problem I went back and opened more of the harness and found a small ground wire that goes to one of the fuse/relay box connectors had melted insulation. I traced the wire back to the connector and found the wire end had in fact h...