|Prev||Professional Automotive Repair Technical Discussions for June 25, 2011
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1993 Dodge Caravan SE 3.3L No Start
While cranking I can see the scan tool shows rpm and says yes to cam and crank signal. I cannot get spark or injector pulse, there is 12v to coil and injectors while cranking but I think the pcm is not grounding circuits. All help will be appreciated, thanks f...
|1996 Dodge Caravan 2.4L wipers, instrument cluster VIN: 2B4FP25B3T
Both rear and front wipers inoperative. However, they can be cycled on and off with fHnctionality test through a hand held scanner. All functionality tests are successful through scanner. There are times when lights in the instrument cluster/panel flash on and...
|2007 Jeep Grand Cherokee Limited 4.7L Poor Idle Quality, Hesitation, Misfire, MIL Lamp on VIN: 1J8HS48P47
Hello everyone, First start off with i hate this jeep, lol. Jeep first came to me about a month ago running rough had a intermiten misfire and a ck eng light on. Scanned pcm and retrived p0305. after switching coils the misfire changed location with coils. r... Trouble codes: P0300 (Random misfire), P0206, P0208, P0204
Fixes & Summaries for Chrysler
|1999 Chrysler Intrepid 2.7L blower motor VIN: 2C3HH46R0X
Thanks to all. Tom from Illinois was correct on checking the resistor. I did not think that the blower motor would "blow open" another resistor in 1 shot, as Brad and Jason also noted. I have replace the resistor and blower motor. A/C and blower controls are f...
|2004 Jeep Wrangler Rubicon 4.0L Hesitation, Surge, Cuts out, Stall VIN: 1J4FA69S24
Thanks for the replies, I tried disconnecting the O2 sensor with no change. I pulled out the ECM connectors and found the middle connector filled with engine oil. I traced it back to the oil pressure switch, it was leaking into the wire and following the curre... Trouble codes: P0157 (O2 Sensor short to ground bank 2 sens. 2), P0158 (O2 Sensor short to power bank 2 sens. 2).
|2006 Jeep Grand Cherokee Limited 5.7L trans &transfer case VIN: 1J4GR48K26
Took the Grand Cherokee to the Chysler dealer for a relearn, came back 99% better shift feel. Iam not sure why snapon or bosch scaner does not support relearn's on the tcm for this vehicle. thanks for the input.