Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for June 24, 2011
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
1995 Dodge Ram 1500 Truck 5.2L Poor Idle Quality VIN: 1B7HF16Y5S
thank you in advance for helping,i have a dodge truck that anytime whether in drive or reverse as soon as you rev the engine and let off the engine dies.going down the road the vehicle dies at stops.watching everything on the scanner iac counts o2 sensor, map ... Trouble codes: 37 (false code)
2007 Dodge Charger R/T 5.7L Cooling Systems VIN: 2B3KA43H17
I have this police car that I don't understand. I made an emissions repair for a MIL light. While I was on my test drive the MIL light returned. I was thinking it was related to what I did. I replaced the leak detection pump for the evap system located in the ...
2008 Dodge Ram 3500 Truck SLT 6.7L limp mode p0871 VIN: 3D3MX48A08
Of course I get this referral with no codes and memory cleared. Customer states it does it mostly when hot and towing or really driving it HARD. He stated it seems to have one common code everyone keeps seeing. Trans. shop told him it needs a computer!! He tow...
1998 Jeep Cherokee Classic 4.0L Poor Idle Quality, Hesitation, Cuts out, Misfire, Poor Fuel Economy, MIL Lamp on VIN: 1J4FT28S7W
hello, ive got a jeep that came in with a complaint of running poorly on acceleration. scanned and found p1391. customer replaced crank sensor and distributor. i was looking on my scan tool for cam/crank sync status and couldnt find it, instead i found reset c... Trouble codes: P1391
2003 Jeep Liberty Sport 3.7L pressure VIN: 1J4GL48KX7
Hey guys this jeep has been flushed, replaced comp,dryer,&liquid line.Vent temp around 70 deg. Low side around 70-80 & high side 225-250.Over charged system and comp pumped to almost 400.Dont that mean the comp. is ok? If I had a restriction wouldnt my suction...

Fixes & Summaries for Chrysler
Fix/Summary Answers
1999 Dodge Intrepid ES 3.2L Reverse VIN: 2B3HD56J8X
Thanks for all the help. I picked up a used trans and will be installing it this weekend.
2002 Dodge Ram 3500 Van 5.2L Surge, Cuts out VIN: 2B5WB35Y52
after getting a few replies about the valve problem i did a running compression test on engine and a couple of cylinders were very low and also had internal vacuum leak so advised customer about results and got ok to remove heads and sure enough about 12 of th...
2004 Dodge Caravan SE 3.3L Mechanical VIN: 1D4GP25RX5
#1 rod bearing hooked. Newer engine going in tomorrow. Thanks for the help guys. Didn't really sound like a rod bearing, but didn't sound like lifter/rocker/camshaft either. Had an engine builder listen to it, and he said definately not bottom end. I'll be tou...
1999 Jeep Grand Cherokee Laredo 4.7L No Start VIN: 1J4GW58N6X
Thank you for confirming my suspicions. I am going to have to replace this engine with the correct year. We even asked them twice if it was compatible, and they said yes, so it looks like they get to eat the labor on this one. Thanks again.
2002 Jeep Wrangler Sport 4.0L excessive pressure VIN: 1J4FA49S62
I replaced the condensor, the dryer and liquid line and orifice tube because the orifice tube located in the liquid line was pushed so far in the line I could not extract it.After repairs the pressures were normal and vent output was 45*.The condensor was hot...
2005 Jeep Grand Cherokee Limited 4.7L Misfire, MIL Lamp on VIN: 1J4HR58N75
I've learned alot on this truck, esp from William from Conn. Modern engines are MUCH "tighter" than I thought possible. Leakdown tests on several cyl were 2-3% leakage (at 116K!). (A BAD cyl is anything over 10%). Ideally I'd do a test when the miss was active... Trouble codes: P0305 (misfire).
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next