Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for April 9, 2011
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
2002 Ford F-250 Super Duty Lariat 7.3L No Start VIN: 1FTNX21F62
Hello, Truck was dropped off as hard start cold,runs rough couple mins then runs good, customer drove truck to shop sat 2 days and I have not had it start as of yet, temp here is about 70. Glow plugs and control working,oil pressure gauge comes right up crank... Trouble codes: P0340, P0470, P1247
View
2004 Ford F-350 Super Duty XL 6.0L No Start, Poor Idle Quality, Hesitation, Cuts out VIN: 1FTSW30P84
Truck came in hard start when hot. Scanned and replaced ficm and towed to dealer to flash,replaced egr, and cleaned. Now it has a p0700 trans. Control system code and intermittent hard start when hot. When it does start it has no power like not firing on all c... Trouble codes: P0611, P0700, P1335, P2614, P2617
View

Fixes & Summaries for Ford
Fix/Summary Answers
1995 Ford Ranger XLT 2.3L Turn Signals VIN: 1FTCR10A5S
yep apparently this truck used to have hitch wiring at front of truck. the wiring was cover with oil between engine and crossmember. pulled the wiring out and found out that the wires were striped. replaced wiring and took care of problem.
9
1997 Ford Explorer XLT 4.0L Poor Idle Quality, Surge, MIL Lamp on VIN: 1FMDU32E0V
Thanks to all the support out there.. This on is not fixed to say.. But there is alot of useful information here. There is a TSB on the timing chain guides breaking on these engine for specific build dates & plants.. Mine was one of those affected.. Built i... Trouble codes: P1506 (Idle Air Control overspeed error), P1000 (OBD II Tests Incomplete).
18
1998 Ford F-150 4.6L Gauge VIN: 1FTZF17WNA
Found that the sender installed was sensor for ECM, removed and installed sender for gausge and it fixed the going hot problem, but now it it only reads cold. It is just an beat up work truck so customer just wanteda add on temp gauge under dash. mThanks for a...
14
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next