|Prev||Professional Automotive Repair Technical Discussions for February 28, 2010
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2002 Chrysler Sebring LX 2.7L Thermostat Housing VIN: 1C3EL46R12
This vehicle came in with coolant leak in the thermostat housing area. This is the 2.7 engine with the thermostat located on the lower LF side of the engine block behind the AC compressor and Alternator. I replaced the thermostat housing, gasket,thermostat,and...
|2008 Chrysler Sebring 2.4L No Start, Poor Idle Quality, Hesitation, Cuts out, Stall, MIL Lamp on VIN: 1C3LC46K08
The customer states the vehicle will run fine and ocassionaly kill when started or while coming to a stop. The concern seems to be intermittent. When the concern is happening the vehicle at times will restart and other times will only crank with a no start con... Trouble codes: P2107 (Electronic Throttle Control Processor)
|2001 Jeep Wrangler Sport 4.0L ecm/ cluster VIN: 1J4FA49S81
jeep is a crank no start, gauges are not working, indicators are proving out, engine light comes on with some delay. pcm is not communicating. put clusterinto self test, have codes 60 and 68. bus codes? fuses are good.
|2005 Jeep Grand Cherokee Limited 4.7L shift motor VIN: 1J4HR48N85
05 Grand Cherokee whineing noise when coasting,we put vehicle on lift and spin the wheels at about 1500 rpm the transfer case shift motor is clearly making the noise.This is a full time 4x4 system,vehicle has ABS,and vehicle stability system.It appears as soon...
Fixes & Summaries for Chrysler
|2003 Chrysler Town & Country (Van) LXi 3.8L ac clutch VIN: 2C4GP54L63
I hate to say it, but I don't think there was anything wrong with this van, or the other one we had that was doing the same thing. These vans are both owned by a used car dealer, and the only reason we were checking the AC was because it was part of a routine ...
|2009 Jeep Wrangler Unlimited Rubicon 3.8L tru lock unit
The only way to allow the switch pushrod to get in place is to pull the differential-electrical clutch assembly out far enough for it to slide by.thanks guys for the attempt sometimes we just have to learn the hard way