 Prev |
Professional Automotive Repair Technical Discussions for September 17, 2009 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 1994 Ford F-350 XL 7.3L No Start, Poor Idle Quality VIN: 1FTHX26F5R When cold this truck will start, early direct injected engine. then when you shut it off, it won't start. No icp (injector control pressure) showing, it does show .24 volt, but when you crank it, it won't go above .50 volt and the pressure readings is 125 psi,... Trouble codes: P1211 (icp pressure above below desired), P1661 (output circuit ck signal low) |
View | |
| 2001 Ford F-250 Super Duty XLT 7.3L No Start VIN: 1FTNW21F91 This Ford came in 3 months ago for a no start. I replaced ICP and then noticed a long crank. Customer declined testing at that time. Now it is back for extended crank. It happens hot or cold. I measured oil pressure at the top of the high pressure reservoir an... Trouble codes: P1211, P1212 |
View | |
| 2002 Ford Focus ZX5 2.0L Cuts out, Stall, MIL Lamp on VIN: 3FAFP37302 car was towed in, we replaced fuel pump assembly, customer drove the car for two months, car came back on tow truck, found no power going to the fuel pump. Rapaired loose connector at inertia switch. Car starts now, but will cut out after about 10-15mins. Ther... Trouble codes: P1237 (Fuel pump secondary system circiut) |
View | |
| 2003 Ford Taurus SE 3.0L Misfire, MIL Lamp on VIN: 1FAFP55263 thanks in advance to anyone willing to help. this taurus came in with a #2 misfire. had original plugs and wires so i started there,swapped coil too. # 2 still misfiring. i checked the injector with amp clamp and found when the car is at idle the signal from t... Trouble codes: P0302 (cylinder 2 misfire) |
View | |
| 2005 Ford F-350 Super Duty XL 6.0L No Start VIN: 1FTWF31P75 hi there. i have a no start condition with this 05 ford 6.0 diesel and this is one of my first diesel diags but i think i have this down to the nitty gritty. any input would be greatly appreciated. first off i know this has a 5 year 100,000 mile warrenty and t... Trouble codes: P0611 (control module configuration incorrect), P0261 (injector 1 circuit low), P0264 (injector 2 circuit low), P0267 (injector 3 circuit low), P0270 (injector 4 circuit low), P0273 (injector 5 circuit low) |
View | |
| 2008 Ford F-250 Super Duty King Ranch 6.4L start relay VIN: 1FTSW21R68 hello to all the ford diesel techs out there.i have a 2008 f250 super duty 6.4.it won't turn over the engine.(start) sometimes.when it won't start i am not getting the ground signal from the ecm to pin 86 on the start relay. i can jump pins 87-30 and vehicle w... |
View | |
| 2009 Lincoln MKX 3.5L srs light on VIN: 2LMDU68C79 i have an air bag light on and i can not find anything about a code B1231 , the car came from a body shop and i have never run into this code before. any help would be greatly appreciated, the body shop said they changed the module and all the parts needed but... |
View | |
| 2004 Mercury Monterey Premier 4.2L Surge VIN: 2MRDA2O234 Vehicle has an engine surge when cold / during warm up. It's fine once its warm. Baro reading is 31.3, local weather station reports 29.8, another ford product (09 crown vic) baro reads 29.5. Where is the baro sensor located. The MAF has the IAT incoporated bu... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 1995 Ford Explorer XLT 4.0L o/d light VIN: 1FMDU34X9S Turns outy guys I had a bad fuel pump relay. It was intermittently cutting fuel off and the signal to the blue #8 wire at the pcm. Replaced and have not heard back so all is good. Thanks to all that repied. |
9 | |
| 1999 Ford Contour LX 2.0L Hesitation, Stall, MIL Lamp on VIN: 1FAFP6535X I found that the mass air sensor harness plugs were loose and not making a good connection on the sensor. I also found a vacuum [...] leaking on bottom of intake. After I tightened the plugs and repair vaccum leak it ran perfect. Thanks to all who replied. Trouble codes: P0102 (maf/vaf circuit low input), P1100 (maf sensor intermitant). |
9 | |
| 2000 Ford F-150 XL 5.4L poor/no heat VIN: 1FTRX18L7Y I removed the cover and checked the blend door actuator operation. The blend door actuator works but the blend door molded plastic shaft is cracked,not allowing it to move in both directions. Thank You everyone for all your great suggestions. |
6 | |
| 2006 Ford Escape Hybrid 2.3L No Start, Cuts out, Stall VIN: 1FMCU96H86 Vehicle went to dealer because there was a recall issue. Customer informed me they changed harness. Thanks to all who helped. Trouble codes: P1A10 (Hybrid Powertrain Control Module Battery disabled), P0A27 (Hybrid Battery Power Off Circut). |
4 | |
| 2006 Ford E-250 5.4L 1-2 shift VIN: 1FTNE24L16 I ordered the an reman trans. Thanks for all your replies guys. I just didn't want to go with a new trans until I had others telling me the same. |
5 | |
| 2007 Ford Edge SEL 3.5L trailer VIN: 2FMDK38C87 Three relays and three fuses sounds about right Tom. And wires that must run from inside the car to the engine compartment fuse panel. That will be and interesting set up. Must come with terminal ends that plug into the bottom of the fuse panel. I will rep... |
3 |
