 Prev |
Professional Automotive Repair Technical Discussions for May 10, 2009 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for GM
| Help Request | Answers | |
| 2000 Chevrolet Camaro Z28 SS 5.7L Intermediate shaft VIN: 2G1FP22G8Y Thanks to everyone first, I need Replacement part G.M. # [...] for this 2000 Camaro. G.M. said the part is no longer made ??? Please Help Thanks, Ken |
View | |
| 2003 GMC Envoy XL SLE 4.2L tcc VIN: 1GKET16S03 attention transmision guys. i need your help on this 4l60e. it is my wife's truck and i have not been able to fix it yet. it feels like a slight misfire under light load either crowding the throttle or pulling a hill. sometimes it will do it on flat ground und... |
View |
Fixes & Summaries for GM
| Fix/Summary | Answers | |
| 2001 Chevrolet Blazer LS 4.3L sun sensor VIN: 1GNCS13W41 Thanks to all that replied the Temp control motor was bad ,it also had a broken blend door motor the clip for the rod broke,cust declined repair at this time,thanks again for the replies. |
3 | |
| 2005 Chevrolet Impala 3.4L TempGauge/ECM VIN: 2G1WF52FX5 Didn't have to replace the IPC. Tried disconnecting BATT terminals and letting it sit for a while. When the terminals were reconnected the temp gauge went back to COLD. The car never really went into LIMP mode. This was falsely reported by the car owners s... |
18 | |
| 1996 GMC C1500 Sierra SL 4.3L MIL Lamp on VIN: 1GTEC14W5T Thanks everyone for your input, found badly worn distributor gear, replaced and adjusted cam retard and no more problems. Trouble codes: P0300. |
25 | |
| 2000 Pontiac Montana 3.4L compressor seal VIN: 1GMDX03E3Y it seems that alot of people still put in compressor front seals but you do ned to be carefull of how much play is in the shaft and that the clutch is working and not getting hot and taking out the seal. i would still leave it up to the customer and choose yo... |
10 |
