|Prev||Professional Automotive Repair Technical Discussions for May 10, 2009
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for European
|1994 BMW 740iL 4.0L Drive VIN: WBAGD8329R
My problem is I can't access the Trans computer to get information. I don't have access to the Trans operation information. What controls the power to the shift solenoidsí? I have drive one gear forward and reverse. The Trans is not slipping feels like it is i...
Fixes & Summaries for European
|2000 Audi A6 Quattro 2.8L abs, motor VIN: WAUEH24B6Y
disconnected the abs control sprayed the connection with contact enhencer (contact ol from wurth cie) and so far alls good
|1991 BMW 850i 5.0L Steering VIN: 000CB73660
First , Thanks to all who helped with this one , the replies basically pointed to a problem with air in the system or a restriction in the feed side of the system , but the problem was in the pressure line from the pump , the original hose come with a crimp wh...
|2002 Jaguar X-Type 2.5L Surge, MIL on- no P codes VIN: SAJEA51D22
Hello Friends, First I want to thank all that responded, these were all very intellegent replies, all were good and all had some bearing on this repair. Most really hit the nail on the head though because all really understood that for now the problem w... Trouble codes: C1145 (RF ABS wheel speed sensor always present), P0171 (Bank 1 Lean back in January not present now), P0174 (Bank 2 Lean back in January not present now.), P1000 (Typical Ford code for all monitors not ready. MIL not affected.), P1547 (FLight Data recording saved).
|1993 Mercedes-Benz 300SE 3.2L oil gauge VIN: WDBGA32E8P
I had nine replies, all were most helpful, thank you! The short answer is it was a low oil pressure problem caused by a sludge clogged oil filter; new oil and filter fixed it. Now the long answer. We concluded we had a low oil pressure problem, not a gauge ...