 Prev |
Professional Automotive Repair Technical Discussions for March 29, 2009 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2000 Chrysler LHS 3.5L MIL Lamp on VIN: 2C3HC56G7Y Hello everyone, this is my headache. Customer came in with a LHS 3.5 litre with a knocking noise. He thought it was the flywheel but ended up needing an engine. He could not afford a new motor, so I got an engine from the junkyard. The motor I installed was a ... Trouble codes: P0172 |
View | |
| 1999 Dodge Caravan SE 3.3L Excessive Emissions, MIL Lamp on, crank no start VIN: 2B4GP52G8X Here is the scoop on this caravan...At times on cold start the car will crank no start, at this time it has spark but will crank over and smells strong of fuel. The only way to get it to start is to hold your foot to the floor then of course it will run rough ... Trouble codes: P0171 |
View | |
| 1999 Dodge Stratus 2.4L pcm VIN: 1B3EJ46X2X Customer states they were driving vehicle, pulled into drive way to make u-turn and when putting vehicle into reverse it stalled, would not restart had towed to my shop. "No Bus" on Odometer, using Snap-On Solus plugged scan tool into OBD2 connector, going VI... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2002 Jeep Grand Cherokee Laredo 4.0L 2-3 shift and no gears at times VIN: 1J4GW48S22 Thank you all so much for your replies, yes I have found that the "new" trans filter to be plugged with clutch material "mud" just after only 50 miles of driving, as it stands I have informed the customer the choices of rebuilding the original trans or obtaini... |
11 | |
| 2002 Jeep Grand Cherokee Limited 4.7L Starting VIN: 1J4GW58N92 I'm going to close this with a fix. We installed a new ignition switch as SKIM and solenoids and range sensor did not appear to be the problem. Wiring was undamaged as well. Switch has been in for a few days now with no further problems reported, but still may... |
12 |
