Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for May 27, 2008
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
1990 Chrysler New Yorker Fifth Avenue 3.3L Electronic VIN: 1C3XY66R8L
This car came to me in limp in mode. I turned key off then back on and it will drive normally. The problem occurs when shifting. When I shift from P, N, or D into reverse it will go into limp in mode, but not on every shift. It has done this in as few as 4 shi...
View
1961 Dodge power wagon 318CID valves VIN: 2380114597
Hello again all and thanks again in advance for all help. We are in the midst of a restore on this power wagon firetruck. Heads have been reconditioned and some valves are hanging open. We re-removed the heads and sent back to the machine shop to check valve i...
View
1983 Dodge 400 2.2L brakes VIN: 1B3BV55C9D
Hi Guys, I'm stumped. This one was driven in with the front right wheel red hot. It melted the center cap on this rim. The hose was collapsed inside causing the lockup. We replaced the hose and bled the system. Now all of a sudden the pedal went down to where ...
View
1994 Dodge Spirit 2.5L No Start VIN: 1B3AA46K4R
hello everyone: this is my step daughter's car and of course she can't understand why i can't just walk up to it and say it's fixed.I have a no-start with no spark from coil.i have tried a new pick-up coil no help,new ignition coil also no help.even went so fa...
View
1997 Dodge Grand Caravan ES 3.8L Mechanical VIN: 1B4GP54L0V
vehicle came in with brake pedal all the way to the floor.checked every thing,master cylinder is replaced.every thing is ok.the next day same story.pedal to the floor.replaced master cylinder with a new one,every thing is ok for few days.again same story.pedal...
View
2001 Dodge Dakota 4.7L engine VIN: 1B7GG26N41
hey dodge guys.i just changed the crank sensor in this dakota 4.7 litre.of course it was seized into the block pretty tight and i ended up drilling through it and using a screw attatchment on my small slide hammer puller to remove.my question to those of you w... Trouble codes: P0320
View
2002 Dodge Ram 2500 Truck 5.9L Misfire VIN: 3B7KF23602
Truck was under hard acceleration during take off in first gear, it hit just under 3000 rpm and missed just slightly. Continued to drive and noticed the check engine light was on, pulled over and checked for codes p1690 is the only stored code. Is this a sign ... Trouble codes: P1690
View
2002 Dodge Intrepid SE 2.7L mode door actuator VIN: 2B3HD46R02
Heating system mode door will not change position. Pulled mode door actuator and physically checked for stuck or binding door, door is free. Checked power and ground going to Manual control head and mode door actuator, all powers and grounds are present. The t...
View
2007 Dodge Ram 3500 Truck ST 5.9L exterior lights VIN: 3D7MX48C47
Electrical power appears to be bleeding into two systems. When the brake pedal is depressed, the clearance lmps, rt rear side lmps, and rt frnt parklamp will illuminate along with the brake lamps. With the brake off and rt turn lmp on the system works fine. ...
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
1998 Dodge Caravan 3.3L Unknown VIN: 1P4GP45G5W
Hi, Thank you to everyone. I mean it. I know how hard it is to take time out of a busy day to respond to a question. As almost all of you stated, it turned out to be the H Block. Replaced it and everything is working fine. Jim [...]
31
1999 Dodge Intrepid ES 3.2L Body Module/a/c VIN: 2B3HD56J9X
The body control module fixed the problem, with the new module I have a good 5 volt reading at the evap temp sensor, the a/c system starting working normally. Still do not know what caused the failure of the old module. Thanks for the replies.
5
2003 Dodge Grand Caravan SE 3.3L gages, warning lights VIN: 1D4GP24313
tHANKS FOR ALL YOUR HELP. i PULLED THE CLUSTER AND INSPECTED IT , THE ONLY THING I FOUND WAS SOME WHITE STUFF ON THE BACK OF THE PRINTED CIRCUTE . i CLEANED IT AND RETESTED IT WITH NO LUCK. tOOK IT THE DEALER SHIP AND HAD A NEW CLUSTER INSTALLED AND THE PROBLE...
9
2003 Dodge Ram 2500 Truck 5.9L Mode control in a/c head VIN: 3D7KA286X3
Replies suggested broken linkage to various doors so I dug deeper. The mode door was broken, the white link between the actuator and door had the stop broken off in such a way that without a real close look and without knowing any better, I didn't catch it the...
3
2006 Dodge Ram 2500 Truck SLT 5.9L Cuts out VIN: 3D7KR28C96
I want to thank everyone for helping out on this one. most of you suggested restriction, some said air in fuel. well i did not find any split lines or leaks,what i found was a restricted strainer.the float was worn out on the edges and some of this hard mater... Trouble codes: P0148 (Fuel delivery malfunction).
11
1987 Jeep Wrangler Sport 4.2L 5th gear VIN: 2BCCL81K3H
I made a shim for clearnce 5th gear shaft to out put housing and that took care of it. thanks to every one . Don g.
7
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next