Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for May 26, 2008
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
1990 Chrysler New Yorker Fifth Avenue 3.3L Electronic VIN: 1C3XY66R8L
This car came to me in limp in mode. I turned key off then back on and it will drive normally. The problem occurs when shifting. When I shift from P, N, or D into reverse it will go into limp in mode, but not on every shift. It has done this in as few as 4 shi...
View
1994 Dodge Dakota 3.9L Cuts out, Misfire VIN: 1B7GG26XXR
I have worked on this truck off and on for two months.The problem is an intermittent miss.It can happen ten times a day or not for a week. It seems worse hot but can happen cold.Light accelleration just before the 1-2 shift or just after seems to be the best t...
View
2001 Dodge Intrepid ES 2.7L Starting VIN: 2B3HD43R31
Hello, I have this Intrepid that came in with a 5 amp draw. We found the draw to be the ASD relay. Simple enough. Went to Chrysler, got relay, installed , no draw. Went inside and turned key,no start! Putin old relay, draw reappears, but car starts. Any Ideas?
View
2002 Dodge Grand Caravan EX 3.8L Power Liftgate VIN: 2B4GP74L42
Thank to all who take time to give any helpful advice. First of all this is an automatic power liftgate and when the gate is actuated the selonoid engages the gears and the motor turns a very little bit and then everything disengages and it all stops. I took m...
View
2003 Dodge Intrepid ES 3.5L Excessive Emissions VIN: 2C3HH56M13
all the oz sensor are reading 3.90 staying lean no matter what i do it stays there moves a little but no moveing from 1 to 9 flexing it goes to & from 3.90 to 3.10 try a new one no change any help would be great great site to be on knox fail & co on cruise is ...
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
1996 Chrysler Town & Country (Van) 3.8L Cuts out, Stall, Misfire, MIL Lamp on VIN: 1C4GP54L6T
Ok it turns out that the new cam sensor that I installed was defective. I cold soaked the sensor and re-installed it and problem would go away. I ordered a new sensor from autozone and problem solved. The problem that i ran into though is out of 4 sensors a d... Trouble codes: P0352, P1391.
8
1992 Jeep Wrangler 4.0L Steering Column VIN: 2J4FY29S0M
sorry for the delay, I found I needed an extra peice like jimmy stated. If it is one thing I have found is that body lifts are bad, Suspension lifts are good. I dont work much on modified stuff like I stated but looked the jeep over and found the body lift poi...
3
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next