P0320 Diagnostic Trouble Code Discussion for May 2008
No Crank Reference Signal To PCM
Note: This is a professional automotive technician's resource.
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.Trouble Ticket Help Requests for DTC P0320
| Help Request | Posted | |
| 1999 Mercury Sable GS 3.0L No Start VIN: 1MEFM50U1X P0320: ignition/dist engine speed circuit fault. ... for help on this vehicle. Vehicle was initially towed in as a no start problem. However, vehicle started right up upon arrival. Vehicle started all that day without a problem. The following morning vehicle started up and I test drove it approximately 3 mil... |
May 07, 2008 | |
| 1999 Ford Windstar LX 3.8L No Start, Stall, MIL Lamp on VIN: 2FMZA5145X P0320: ignition diagnostic moniter. ... seen before. Vehicle started out stalling sometimes as if a bad IAC with no codes. It would not do it when at the shop. Then started stalling while going down the road and set the P0320 code. It would start back up found no problem when got it back to shop... |
May 12, 2008 | |
| 2000 Mercury Cougar 2.5L Hesitation, Cuts out, Stall, Misfire, MIL Lamp on VIN: 1ZWFT61L3Y P0320: erractic ignition. hello. This car is really strange. It was cut out and barely run in drive but does fine in park reverse neutral. we have replaced crank sensor and computer but still no change. I have tried to look misfire graph with IDS and it says cam and crank not synch. It... |
May 16, 2008 | |
| 1998 Dodge B2500 5.2L No Start, Surge, MIL Lamp on VIN: 2B4JB25Y2W P0320: No Crank Reference Signal to PCM. ... Rotor, Cap, Coil, Wires. After replacing all of these items the code P1391 still comes back. Replaced the PCM because the IAC Test failed. Checked all wiring, OHM and Voltage were all good. Before replacing the coil, cylinders 4,8 were intermittently misfi... |
May 19, 2008 | |
| 2002 Jeep Liberty Limited 3.7L Hesitation, Stall, MIL Lamp on, Intermittent drivabi VIN: 1J4GL58K62 P0320: No Crank Reference Signal At PCM. My question is what is the engine speed sensor.This vehicle has input shaft and output shaft speed sensors.Is one of them used as the engine speed sensor? I cant find anything in mitchell and I have the factory service manual and code P0725 is not found anywhe... |
May 24, 2008 | |
| 2001 Dodge Dakota 4.7L engine VIN: 1B7GG26N41 P0320: No Crank Reference Signal to PCM. hey dodge guys.i just changed the crank sensor in this dakota 4.7 litre.of course it was seized into the block pretty tight and i ended up drilling through it and using a screw attatchment on my small slide hammer puller to remove.my question to those of you w... |
May 27, 2008 |
