|
|
1994 Honda Accord 2.2L window glass Customer concerning all the window glass are forger/clouded
up after park or driving. After clean with windshield
cleaner it help for few days then it coming back again.
Please, if everyone running to this concern and know what
is need to fix it and respond to... |
View |
|
2005 Honda Odyssey 3.5L reverse Customer brought in this honda with 54000 miles he said it
started gringing in rev when he backed out of his garage
some times. Now it grinds in rev & park all the time. we
replaced the tranny with a used one same problem. so we
install A, B, & C, pressure sol... |
View |
|
2005 Honda Odyssey 3.5L reverse Customer brought in this honda with 54000 miles he said it
started gringing in rev when he backed out of his garage
some times. Now it grinds in rev & park all the time. we
replaced the tranny with a used one same problem. so we
install A, B, & C, pressure sol... |
View |
|
1995 Infiniti G20 2.0L power window hey infinity / nissan techs. i have this 95 infinity g20
the drivers power window is inop but all other windows
work. the power window motor and switch at the drivers door
have been replaced all the switches in the center console
work fine. i cant seem to find... |
View |
|
2002 Kia Sportage 2.0L front wipers went on mitchell and got wire diagram tested circut at sw
had power went to plug on motor check no power motor good |
View |
|
2000 Mitsubishi Eclipse 2.4L Engine Thanks in advance for all info. This one has us wondering.
This car overheats when idling. If you watch the temp on
the scanner, it starts climbing until it overheats. Fan
runs but does not cycle. Air coming from fan is cool, as is
the lower hose. If you hold ... |
View |
|
2001 Nissan Sentra 1.8L Hesitation, Surge, Cuts out This nissan got a big hesitation when we drove at 100 kmh
and more ,the car feel like if it loose fuel pressure ,but
pressure is good ,the car is also lossing power at all
speed and we fill that its not a cylinder but all the
engine .its a crashed car and the ... Trouble codes: p0130 (ho2s lean), p0131 (ho2s bank 1), p0705 (pn switch). |
View |
|
2005 Nissan Altima 3.5L starter, Blown fuse Car was towed into shop with no start, Found fuse #12
blown,controls starter relay heater and A\C controls shift
interlock, and IPDM module.Replaced fuse and all was well
for a day,test drove the car and when i came to a stop and
put the car in park the fuse p... |
View |
|
1996 Subaru Legacy 2.2L No Start, Poor Idle Quality, Hesitation, Cuts out, Stall I have posted several times without any luck:
Issue: Car runs perfect and for no reason after long drive,
the car will not start. Only way to get it to start is to
keep pumping the gas pedal. Once it starts it runs so rich
and smells awful, and it feels like ... |
View |
|
2000 Toyota Camry 3.0L sln solenoid P1765 - Open/Short in SLN Solenoid Circuit, checked
everything by Snap-on Moduis checked out fine, Check
everything by Alldata checked out fine, EXCEPT Duty Cycle
values. Flushed Transmission cleared Codes Code reappears.
Took Pan off transmission to check Sol... |
View |
|
2000 Acura RL 3.5L insturment cluster Thanks to everyone who replied, we have repaired this vehicle. After consulting with my tech, I went back to basics(powers and grounds). I decided to tackle this myself, I found that the c325 connecter under the drivers foot rest was severly corroded and when ... |
3 |
|
1999 Lexus ES300 3.0L convertor lock alright so i fixxed the vehicle, i did not leave any connections loose or unplugged. my best guess is when i cleaned all the oil residue off the o2 sensors, or when i disconnected the battery it may have reset adaptives, never the less after engine warms up tr... |
8 |
|
1995 Mazda Miata 1.8L tachometer thanks guys for the help installed a used ecm to see what would happen and the ecm took care of the problem again thanks for the help Ben |
3 |
|
2008 Nissan VERSA 1.8L blower motor EASY REMOVAL- TAKE OUT GLOVE BOX LOOSEN RT AIR DUCT- TURN MOTOR CLOCKWISE IN HEATER BOX AND OUT SHE COMES. |
1 |
|
1989 Toyota Land Cruiser 4.0L Cuts out, Misfire It did seem to finally be a fuel problem. I was able to get enough enrichment by using my injector pulse tester on the cold start injector to make the problem go away while it was happening. I did clean the injectors but no change. I think the problem is in... |
4 |
|