|
|
1997 Honda Accord 2.2L Poor Idle Quality, Hesitation, Misfire, MIL Lamp on
Hi fellow Tech/Honda techs Car came in with a misfire, did
basic tune up (Plugs NGK) ,cables, dist cap and rotor, car
ran much better but still had and little misfire On #1 & #2
had a distributor to try out still the same, tested crank
sensor Good. changed # 1... Trouble codes: P1300 (Controlled ignition system or misfire), P0301 (1 Misfire), P0302 (2 misfire), P0135 (B 1 S1 Heater), P0141 (B 1 S 2 heater circuit). |
View |
|
2001 Kia Optima 2.4L MIL Lamp on
need some help please.not to familiar with kia systems.got
a code po171.was in a week ago and found pcv hose
loose.repaired line and now vehicle back with code
po171.any help or ideas would be greatly appriciated Trouble codes: 171. |
View |
|
1999 Mazda 626 2.0L left outer joint
We have been chasing this issue for months now. The drivers
outer axle joint will click on turning after about 2000
miles of driving. We have put 6 axles from various remans
and some new. Always the same result. All motor mounts are
good. Alignment good. Equal... |
View |
|
2004 Mazda MPV 3.0L Misfire, MIL Lamp on
OK, here it goes. COP ignition system with coil drivers in
the ECM. Right from the door I ohmed out the primary and
secondary coils on cylinders 4,5,6. That is the front bank
near radiator. Secondly I fired up the Modis and my low amp
current tester and checke... Trouble codes: P0304 (cyl 4 misfire). |
View |
|
1988 Toyota Pickup 2.4L retro-fit
I am starting to get into A/C work and I would like to know
what the majority of all of you guys do when reto-fitting
vehicles. I have a R134 machine only so I have been letting
the freon out in the atmosphere and the vaccuming the
system with the machine, rep... |
View |
|
1989 Toyota Camry 2.0L 2-3 shift, 3-4 shift
This camry will not shift past second gear most of the
time. It has no codes in the ecu but I can induce a code
and it will store it until cleared. The tranny passes the
manuel test and shifts as it should when the ecu is
disabled. I have ran all the wire test... |
View |
|
1992 Toyota Camry 2.2L Code 41
This car came in with no head lights. we diagnosed it as
bad headlight switch. We had to remove the air bag and
steering wheel to access the headlight switch. In the
process we disconnected the battery, waited 3 minutes, and
disconnected the air bag. Should ha... |
View |
|
1995 Toyota Tacoma 2.4L Hesitation, Cuts out, Misfire
Well This car came in on a hook no start. I found no spark
Crank sensor was bad and plug wires cap rotor and plugs
never changed in 200000+ miles replaced parts. This truck
has a miss fire under load ING shows on scope normal even
under load. Scanner Shows tha... |
View |
|
2000 Honda Accord 2.3L MIL Lamp on
After getting a sensor from the dealer and testing all inputs and outputs from ECM. We also ohm tested all wires and decided the ECM is bad. Trying to find a used one for customer Trouble codes: P1167 (1 air fuel sensor heater system fault). |
12 |
|
2002 Hyundai Elantra 2.0L range senor
I change the range sensor, talk to the guys at the dealer and was given a print out on installation. I did every thing and i notice that as a general practioner, i had to ask the obvious becasue i know that the steps at the dealer are totally different from af... |
3 |
|
1995 Infiniti G20 2.0L power window
finally got this one found broken wire under center console that feeds the sub switch in the door thanks for the replies
|
2 |
|
2002 Kia Sedona 3.5L posssible lockup
Well I drove it for about 100 kms and it did not set a code or act up on me. I talked with our trany rebuilder and they actually have not worked on alot of kias. I beleive there is either something sticking inside or pressure bypassing internally, causing the ... |
3 |
|
2002 Kia Sportage 2.0L front wipers
Thanks guys for the lead I found the red/blk wire cut thru on the pass side of firewall repaired and we're all happy.
Many thanks to all you folks for the help,iATN is worth every penny |
3 |
|
2001 Toyota Sienna 3.0L Hesitation
thanks to all that replied. found that the timing belt sprocket had been rocking back and forth on the woodruff key and hammered the groove out on the sprocket. (thanks george from california) also the sproket moving back and forth on the crank put a step on t... |
8 |
|
2002 Toyota Tacoma 2.7L No Start
WE tested for purge valve staying open but since the last post the vehicle has not had another incident.Most likely the valve was the problem but as of now we did nothing to repair the problem until it occurs again. Trouble codes: P0441. |
6 |
|
2002 Toyota Camry 2.4L reverse
Hello everyone and thanks for the help that was offered on this one. We got a few responses telling us to look for mounts moving too far and clicking the shift lever into neutral. We eliminated this by taking the shift cable off the trans and the problem sti... |
5 |
|
2004 Toyota Tacoma 3.4L 4 wd
Thanks for the help. The accuator on the front axle was shorted out because of water getting in it through the vent hose. Seems the truck has been in some deep water.. |
3 |
|
2004 Toyota Sienna 3.3L Poor Idle Quality, MIL Lamp on, Blown Fuse
Well, vehicle is gone, I could not duplicate, I like the dirty throttle bore sugestion- I would have liked to seen the throttle stick for myself to prove it was the culprit, but it worked fine when I recieved the car, I will update if vehicle returns Trouble codes: P2118 (Circuit Problem- Idle Motor). |
2 |
|
Prev
