|
|
2000 Chrysler Town & Country 3.8L tcm
hey guys this van has no communication with my modis and i
have a no ccd message from tcm code p1698 check the ccd bus
lines i have 2.2 volts and great coninuity to pcm and dlc.
the tcm is not turning on the transmission control relay
and i have no really good... |
View |
|
2004 Chrysler Concorde 3.5L Noise
Noise/Grone/Vib happens at low speeds only. Can get it by
stressing the engine just slightly in gear and foot on the
brake. Noise is coming from Alt.area. Removed belt, nose is
gone. Alt,PS, and tensioner all feel fine. All brackets are
tight no visable cracks... |
View |
|
1997 Dodge Stratus 2.5L Poor Idle Quality, Hesitation, Misfire, MIL Lamp on
Engine runs rough at idle and hesitates on acceleration. I
tried to motorvac the vehicle but no help. Fuel pressure is
good. Volume is good. Checked for vacuum leaks with smoke
machine. No leaks found. I'm thinking I have partially
plugged injectors. I don't r... Trouble codes: P0300 (Randommultiple misfire detected.), P0171 (System too lean bank 1). |
View |
|
1998 Dodge Caravan 3.3L emmision rejection
monitors not run,after drive cycle.on otc scanner is going
back pcm to abale to diable.im thinking pcm? help me out
chry. fans.vehicle is not failed emmis. its been an reject.
youy help would be great. |
View |
|
2002 Dodge Stratus 3.0L 3-4 shift
lets start by saying thanks to anyone can help car came in
trans slips in all gears fluid burned up sent trans out to
rebuild came back with slight slip going into 4 th tried
another unit did exact same thing have tried all solenoids
still same car has after m... |
View |
|
2002 Dodge Caravan 3.3L Limp Mode
Im stuck in limp with code 725 (Speed sensor prob) which
will return during a test drive after being canceled.
During that short window, trans shifts normal. I did wire
in new pigtails to both speed sensors, to no avail. My
scanner shows RPM's on both input an... |
View |
|
2003 Dodge Neon 2.0L guages
Members, thanks for any help in advance! Our customers
complaint was having the fuel and temp gauges go to max
while at the same time the speedometer would drop to zero.
condition would duplicate only if vehicle had sat for more
than thirty minutes. Once start... |
View |
|
2004 Dodge Stratus 2.7L timing
Thanks in advance for any help. This car came in with a
leaking water pump, so I pulled the timing chain off and
changed out the pump. Timing is right on and I installed a
new tensioner. After putting the car back together it would
not start. Pulled the valve ... |
View |
|
1999 Jeep Grand Cherokee 4.7L Stall
The complaint is that this Jeep will occasionally die while
driving. It will restart and run ok until next time. After
much driving I haven't been able to get it to die but I did
get it to set code P0108, map sensor voltage high.
According to the freeze frame,... Trouble codes: PP0108 (Map sensor voltage too high). |
View |
|
2003 Jeep G. Cherokee 2.7L solenoid
Hello
This WG 2003 Grand Cherokee is europen diesel version (2.7
CRD). Engine and transmission from Mercedes.
TCM will go to limp home mode sometimes with code "Power
supply to solenoid". ECM will set code P0700.
There is a TSB (21-009-08) regarding a very ... |
View |
|
2004 Chrysler Pacifica 3.5L drivers side windows inop
Well, after lots of time, very intermitant problem, found partially broken wire in the harness near the kick panel. Next time I'll know where to look!!! |
1 |
|
1990 Dodge Dakota 3.9L rear main seal
Hello and thank you all. Most everyone said there is a tool for this. I couldn't get one today. Others said a wire worked around to loosen had been tryed. I already had the timing chain off for replacement so I unbolted the converter and crossmember then loos... |
15 |
|
2000 Dodge Grand Caravan 3.0L Low vacume, power
I got this van figured out friday night but waited till parts were order and installed to confirm. After spending more time with fuel and tried to trick the fuel trim, it always compesated correctly. It's working fine. Check cam lobes, found #6 intake ground d... |
10 |
|
2002 Dodge Caravan 3.3L limp mode
WELL AFTER 3 PLUS DAYS, AND 2 TRIES AT DART DIAGNOSTICS AND FAILING, I TOOK A STEP BACK. I STARTED OVER WITH RECHECKING POWERS AND GROUNDS TO THE TCM AND PCM AND ALL WAS STILL GOOD. I WAS STILL MISSING RELAY POWER SO I CHECKED POWERS AND GROUNDS AT THE FUSE BO... |
13 |
|
2004 Dodge Pickup 5.9L heater
it was the door flap that makes heater & defrost fix it and working find thanks to jeff i could not see the motor for defrost took it off & it was strip plastic cheap dodge they should put some steel rod in there so thank you i like iatn its great lots off goo... |
1 |
|
2005 Dodge Durango 4.7L dome lights, dimmer switch and curtesy lighting u
THERE WAS A LOOSE CONNECTION @ C3 OF INSTRUMENT CLUSTER, I APPRECIATE THE IDEAS GUYS THANKYOU. |
7 |
|
2005 Dodge Pickup 4.7L Stall, MIL Lamp on
I would like to say "Thank You" to all of you that gave me terrific input on this situation. I would also like to give a special Thanks to Robert [...], Tom [...] & Gilbert [...] for nailing this diagnosis right on the head. The problem was I did not discon... Trouble codes: PO404 (EGR Position Sensor Performance), PO405 (EGR Position Sensor Circuit Low). |
10 |
|
1997 Plymouth Grand Voyager 3.3L No Start
Not a lot of replies on this one, I haven't fixed it yet either. Scoping the cam and crank sensors on this van and a running van, the signals are clean and aligned almost exactly relative to one another. I took the PCM from the non-running van and installed it... |
7 |
|
Prev
