|
|
1988 Ford Econoline 7.5L No Start
I have this van that came in for a dying & low power. I
have checked fuel press (41 lbs) also the exhaust it showed
about 2.5 lbs so took the pipes loose from the manifolds. I
still have the same problem so I pluged the return fuel
line to increase fuel press ... |
View |
|
1994 Ford Econoline 4.9L Cuts out
I have a delivery van thats acting funny. It has one code
for spark output circut.I have alldata and the test calls
for the BOB. I dont have access to a break out box. Is
there any other way to test for this code? Trouble codes: 213 (Spark output circut open). |
View |
|
1995 Ford Pickup 7.5L radiator
this has been baffling all involved this was a preveously
rebuilt engine 3 years ago by another shop. It came to us
last fall running overheating, we put on a water pump and
fan clutch. no help. replaced the radiator no help. The
customer needed the truck so h... |
View |
|
1996 Ford Contour 2.0L ignition fuse
got this one for a no start. ignition/drl fuse was blown.
it is fuse #4 in the underhood fuse panel. it protects the
alternater, ignition coil and the pcm power relay. put in
new fuse and it ran fine for approx 1 hour, tried to find
reason for blown fuse (none... |
View |
|
2003 Ford F550 Super Duty 6.8L Poor Idle Quality, Misfire
Hello, We have this 2003 F550 CrewCab Box truck with 6.8 L
V10. The truck has an intermittant miss that will come and
go at idle. It will also intermittantly miss on accel.,
sometimes a pretty solid miss, other times a very faint
miss, other times not there at... |
View |
|
2003 Ford Ranger 2.3L No Start
first of all, i want to say thanks in advance for the your
time, hope somebody had this problem before. this ranger
came in towed with a cranks wont start problem, we could
never duplicate customer complaint at work. we replace IAC
valve because idle won't go ... |
View |
|
2005 Ford Pickup 5.4L MIL Lamp on
P0174, Bank 2 lean code. Fuel trims however show both banks
lean. Thought we had this one fixed when we replaced the
plugged fuel filter. Truck came back with same code. Fuel
rail pressure holds at 39-40. Freeze frame st1= 2.3 st2=
-3.9 LFT1=15 LFT2= 20. ECT= ... Trouble codes: P0174 (Bank 2 lean). |
View |
|
2005 Ford Five Hundred 3.0L Late shifts /med throttle
Driving @ light throttle the transmission will upshift
gears 1 thur 6 by about 50 mph with tp% @ about 25 to 30%.
With med throttle transmission will wind out to 4,500 or
5,000 rpm's unless you lift pedal.
This car has the CAN system, has anyone runinto this... |
View |
|
2005 Ford Econoline 5.4L MIL Lamp on, low power
I need some help on this on.I have not run across this code
before. Driver complained about no throttle responce, Fond
some blown fuses. Van will run fine in the shop. No codes
for koer or pending. Took for test drive and shure enghough
as soon as I went to ge... Trouble codes: p2107 (throttle acuator control module pprossor), p2110 (throtle sctuator control forced limit rpm). |
View |
|
2004 Lincoln Navigator 5.4L Hesitation, Cuts out
vehicle hesitates under a load on acceleration. we swept
the tps. working ok. fuel pressure does no drop when it
cuts out. when it first came in there were no codes. after
it started acting up we found po320. then once in awhile it
will barely run and the code... Trouble codes: PO, 320 (ckp circuit), PO351 (ign coil primarysecondary). |
View |
|
1987 Ford Pickup 4.9L Fuel gage
Hi to all iatn members who took their valuable time to read and respond to my help request. Although the problem turn out to be a commun defect in this particular vehicle, it help me a lot. After explaining to customer about the irregularity of the fuel gage, ... |
17 |
|
1997 Ford Explorer 4.0L MIL Lamp on
This explorer hasn't been back yet, but I was told the check engine light is still on the gas cap didn't fix it. I'm still curious how a re-flash could effect the parameters for setting this code. Trouble codes: p0466 (Purge Flow Sensor Circuit Range). |
5 |
|
1998 Ford Pickup 4.6L MIL Lamp on
Thank you for all the replies. I knew about the vacuume leaks at the pcv, but had never seen an egr valve leak out the vent holes under the casing. I cleaned the maf and replaced a stuck pcv valve. Codes are gone and idle is much better. |
21 |
|
2000 Ford Windstar 3.8L engine
THANK YOU FOR ALL WHO RESPONDED, MOST OF THE SUGGESTION HAD BEEN TRIED, WE DID REMOVE THE ENGINE AND TRANSMISSION AGAIN AND FOUND THAT THE FLYWHEEL DID HAVE A WEIGHT ON IT, WE CHANGED BACK TO ONE WITHOUT WEIGHT BUT IT STILL HAS THE SAME VIBRATION. THE HARMONIC... |
9 |
|
2001 Ford Taurus 3.0L Surge
Thanks to Jim and Ed for their help. Ed was right, the PCV valve was stuck open. I elected to remove it to check it out, could blow through it both ways. Put a new one in it, and it runs great. Not really a bad job, its alot easier than it looks, after you rem... |
2 |
|
2001 Ford Pickup 7.3L prolonged crank time
Cleaning IC regulator, resealing injectors, and 2 good batteries seems to have this one up and running. I was waiting for customer reply, but haven't heard anything yet. I guess no news is good news. Trouble codes: p1212 (ICP not detected during crank). |
5 |
|
2002 Ford Taurus 3.0L Misfire, MIL Lamp on
Thanks to all who replied. yes it was the ecm;s coil driver that was bad. i lab scoped the primary pattern for for cyl #3.#4 right out of the ecm and it was not good compared to other cylinders... Trouble codes: p0352 (ignition coil A thru J primarysecondary circuit malfuntion). |
6 |
|
2004 Ford Pickup 6.0L Excessive Emissions, NO POWER
thanks for all the replies the codes for exhaust back pressure were the problem seems there must be some recall for the plugs on the exhaust back pressure sensor the plug was replaced about 4 inches up in the wiring harness repaired plug and truck runs great b... Trouble codes: po46 (bypass control valve circuit range perf), p0470 (exhaust back press circuit malfunction). |
4 |
|
2005 Ford Freestar 3.9L Poor Idle Quality, Hesitation, Cuts out, MIL Lamp on
Jim was completely correct!! The PCM was giving data but it needed to be programed for the correct car, therefore that data was incorrect. Thanks for the help guys. Dewey Trouble codes: P1288 (Cyl head temp sensor out of range), P1711 (TFT Sensor out of range), P0603 (Internal control mod Kam error). |
3 |
|
Prev
