|
|
1986 Ford Pickup 5.0L No Start
I have this 86 f150 with no start concern, check fuel psi 0
check spark (good). I hooked up a jumper wire to ground and
at the fuel pump test terminal at DLC connector and now I
have 40 psi of fuel pressure. truck runs, dissconnect
ground wire while truck is r... Trouble codes: 31 (egr), 42 (ego not switching). |
View |
|
1995 Ford Pickup 7.5L radiator
this has been baffling all involved this was a preveously
rebuilt engine 3 years ago by another shop. It came to us
last fall running overheating, we put on a water pump and
fan clutch. no help. replaced the radiator no help. The
customer needed the truck so h... |
View |
|
1996 Ford Contour 2.0L ignition fuse
got this one for a no start. ignition/drl fuse was blown.
it is fuse #4 in the underhood fuse panel. it protects the
alternater, ignition coil and the pcm power relay. put in
new fuse and it ran fine for approx 1 hour, tried to find
reason for blown fuse (none... |
View |
|
1996 Ford Econoline 4.9L blinkers
replaced blinker switch and checked grounds.Put on flashers
work fine.but as soon as blinkers put on blows fuse.checked
wireing around colum and bulbs look fine. |
View |
|
1998 Ford Windstar 3.8L Hesitation, Misfire, Poor Fuel Economy
Hello, thank you all in advance. This 98 Windstar came in
with a Code P0340 continuous KOEO. Removed CMP and found
the magnet part gone and the vane on the housing mangled.
Replaced both but we had no special tool for setting the
CMP timing. Also I don't see a... |
View |
|
2004 Ford F650 Super D 7.3L no shift, no speedometer
I have a prolink scanner with the allison trans software
and found no codes. I have hand over hand the harness
looking for any harness problem and found none. I can't
find a schematic on this truck. I have big truck mitchell
and it kind of skips around this da... |
View |
|
2000 Lincoln Continental 4.6L tcc
this car came in months ago, and had a slipping problem. we
rebuilt it and in ten miles the check trans light came on
with a p1744 code. we pulled the valve body and found the
pump shaft seals were torn up and the pump shaft sleeve was
torn up along with the b... |
View |
|
1996 Mercury Cougar 4.6L Poor Idle Quality, Idle Surge
Car has a bit of a low idle & also a rhythmic surge at the
same time when warm. Worse in gear . Drives fine going down
the road .
Fuel trims are running right about 0 .Near perfect. MAF is
running 7-8 gps in neutral & 5-6 in gear . All other sensor
readings ... |
View |
|
1998 Mercury Mystique 2.0L motor mounts
Car came in with rattling noise. Replaced all 4 motor
mounts with OEM parts from dealer. Noise still coming from
the timing belt side. With air-condition on, the noise gets
worse. Any help from Ford tech would be greatly
appreciated. |
View |
|
1998 Ford Econoline 5.4L MIL Lamp on
Firstly, Thank you everybody for your help. Some of the tests that I did. I forgot to mention was that fuel presure was at specs, KOEO and KOER, each time the van was here I cleaned the MAF sensor and check for vacumm leaks with smoke machine I olso noticed th... Trouble codes: P0171 (System too lean bank 1), P0174 (System too lean bank 2). |
12 |
|
1998 Ford Pickup 4.6L Misfire, MIL Lamp on
Hi :
Sorry for the late reply. I was expecting the customer will come back for further testing but having seen the car yet,so no information i can provide right now. However,i received few good suggestions which will help me in the future. Thanks for helping... Trouble codes: P0304 (cylinder number 4 misfire), P0133 (oxygen sensor bank i sensor 1 slow respones). |
19 |
|
2002 Ford Escape 3.0L convertor
Unfortunately we don't have a fix on this one. the customer took the vehicle to the dealer to flash computer (wouldn't run rediness monitors for egr or evap) and we haven't seen it since.
As lance suggested we checked and changed fuel filter.While this seem... |
3 |
|
2005 Ford Pickup 5.4L Poor Idle Quality, Misfire, MIL Lamp on
well thanks to everyone for responding especially nick from ohio. I sent the truck to ford to reflash computer and they couldn't they told me the computer was bad from the failed coils burning up the coil drivers in the coil driver module so they replaced the ... Trouble codes: po104 (maf erratic), po351 (ignition coil circuit), po356 (ignition coil circuit), po506 (idle below normal). |
3 |
|
Prev
