|Prev||Professional Automotive Repair Technical Discussions for October 6, 2007
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2007 Dodge Ram 2500 Truck ST 5.9L Excessive Emissions VIN: 3D3KU28C53
Dear Dodge Guru's, I have one that is out there aways. I have been working with diesels for almost 20 years, Customer had us tow to shop. Owner was driving to job a few miles from his place. Started bucking,rpm starting climbing, he turned off key, engine did...
|1987 Jeep Wrangler Laredo 4.2L NO 1st, 3rd or 5th gear VIN: 2BCCL8149H
Hey guys, thanks again for your time to read this. This truck was shifting fine. It had the typical leaking slave/ bearing assy. I pulled it, replaced the clutch kit and machined the flywheel. Upon installation, I lost it off the jack and it bounced off my sho...
|2002 Jeep Grand Cherokee Laredo 4.0L Misfire VIN: 1J4GW48SX2
cleared codes, ran it, drove it cold & hot, 40 miles all together, only got occasional misfires on 3, 4, & 5. leak down & compression test good, checked & replaced plugs, drove again, still occasional misfires, mostly on cyl 3. swapped plugs #1 with #3, inject... Trouble codes: P0303 (Misfire cylinder 3)
Fixes & Summaries for Chrysler
|1984 Dodge D150 5.2L Cuts out, Stall VIN: 1B7GD14T3E
There was a section of rubber line connecting to a metal line from the tank so i shortened it and reinstalled the metal line and blew in the line. Now the vehicle runs great. Thanks for the help guys