|
|
2007 Honda CR-V 2.4L tire pressure monitoring
Hello everyone, this is my daughters car and she came back
from college and let me know it had a light on with the
picture of a flat tire, Well after WE checked all the tires
it did have one low, after having it repaired The light
stayed on of course, now i am... |
View |
|
2004 Hyundai Santa Fe 2.7L Compressor
Customer said she has no AC. I checked the charge amount
and it is correct. I don't have power to the AC clutch. I
tested the relay and the PCM is not grounding the it. I can
ground it and the AC blows cold. I tested my switch input
to the PCM on pin 24 and it... |
View |
|
1999 Infiniti Q45 4.1L expansion valve
The car came in with the a/c not cooling. When I hooked up
gauges and turned on the a/c, the compressor engaged, but
no change in pressures. I replaced the drier and expansion
valve with OEM parts. A/c cooled fine and had good
pressures. The next day, the cust... |
View |
|
1997 Isuzu Rodeo 3.2L Battery
This vehicle is a 3rd car for our customer. It sits for
periods of time. It sat approx. 1 month and was a dead when
the customer tried to start it last week. Charged the
battery up and tested the system. Every thing passed and
seems good. Cables are good. Less... |
View |
|
1997 Isuzu Rodeo 3.2L no communication
I have here a Rodeo that I can't communicate with the ECM.
Someone else (used car lot) has replaced the OBDII
connection. I need verification that all the pins are in
the correct position. I have Mitchell on-demand, but it
shows 2 different configurations of p... |
View |
|
1995 Lexus GS 300 3.0L MIL Lamp on
Greetings, Another mind bender. Car was in our shop for
major work-- steering rack and pump, major service, timing
belt, and the check engine light was on for an EGR
code--only stored code. We ended up cleaning all the EGR
passages and replaced the EGR valve a... Trouble codes: P0300 (Random Misfire), P0301 (Misfire Cylinder 1), P0306 (Misfire Cylinder 6). |
View |
|
1996 Lexus SC 300 3.0L MIL Lamp on
Vehicle came in for oil leaks. Valve cover gaskets, cam
seals, crank seal, P/S pressure hose and steering rack were
replaced. After repairs were completed, MIL illuminated and
began flashing with 3 misfire codes listed below being
stored.
The misfire PIDs fo... Trouble codes: P0300 (Random cylinder misfire), P0301 (Misfire cylinder 1), P0306 (Misfire cylinder 2). |
View |
|
2002 Lexus SC 430 4.3L tire pressur
I replaced the 4 tire pressures sensor since it was the
dealer diagnostic. Now how do I reset the low tire presure
that comes in the dash on this car. |
View |
|
2004 Mazda RX-8 1.3L Poor Idle Quality, Stall, Misfire, MIL Lamp on
Vehicle came in with check engine light on, complaint of
running rough in the morning and blowing white smoke out
exhaust. Scan vehicle for codes, find p0302 rotor #2
misfire. Remove spark plugs and find rear rotor plugs have
rich condition (black), and to hav... Trouble codes: p0302 (Misfire cylinder rotor number two). |
View |
|
2000 Nissan Altima 2.4L MIL Lamp on
This vehicle first came in the shop with SES Light on, with
two codes PO705 & P1706 Neutral Switch problem. Not other
information is avaliable. We shut off the light, and it did
not come back on for a month. Again the customer was back
with same problem. After... Trouble codes: PO705 (Neutral Switch Problem), P1706 (Neutral Switch Problem). |
View |
|
1995 Toyota 4Runner 3.0L Poor Idle Quality, Stall
The whole story - came in the drive shaft had fallen out of
it in the process it cracked the transmision case, broke
the exhaust,took out the heater lines,and a shock.
Everything was replaced that was destroyed. Now it would
idle before the transmission was re... |
View |
|
1995 Toyota Camry 2.2L Poor Performance
I have this Camry that will start and idle fine and
accelerate good when cold. After the car is run a few
minutes and warms up, it will still idle fine and will
accelerate if you accel. slowly. If you accel normal or
quickly, it will bog down real bad and some... |
View |
|
1999 Toyota Tacoma 2.7L Hesitation, Cuts out
Hello toyota gurus. this tacoma with 125,[...] on it
hesitates badly for the first minute of operation.I have
monitored fuel pressure while the hesitation occurs.this
thing acts like its starving for fuel. Another shop has
replaced MAF(toyota) and spark plu... |
View |
|
2000 Toyota RAV4 2.0L MIL Lamp on
Thanks in advance for any help/advice. we have this Rav4
with an intermittent MIL that keeps setting code PO401.
When we test the system components individually,(Vacuum
hoses, VSV, EGR valve, Transducer) they all test good. I
even replaced the transducer to ma... Trouble codes: PO401 (EGR Insufficient flow). |
View |
|
1998 Isuzu Rodeo 2.2L MIL Lamp on
customer picked up truck because he needed it. said he will bring it back later. when he does i'll try putting another cam sensor to see what that does. thanks for all the replies. Trouble codes: p301 (random cylinder missfire). |
9 |
|
2003 Kia Optima 2.4L No Start, MIL Lamp on
Further verified the new sensor with lab scope and showed a flat line all across. Rechecked previous work such as timing belt, water pump and all gears/pulleys alignment.
This vehicle uses crankshaft sensor to trigger ignition and injector pulsing. The fuel p... Trouble codes: PO335 (Crankshaft Position Sensor). |
3 |
|
1999 Lexus ES 300 3.0L MIL Lamp on
I WOULD LIKE TO THANK ALL THE TECHS WHO REPLIED TO THIS POST. I ORDERED THE NEW HARNESS FOR THE KNOCK SENSORS AND REPLACED BOTH SENSORS. THE HARNESS WAS CORRODED VERY BADLY AS YOU STATED IT WOULD BE. REPLACED INTAKE AND PLENUM GASKETS CAR RUNS GOOD AND CHECK E... Trouble codes: PO330 (knock sensor). |
5 |
|
2003 Mitsubishi Lancer 2.0L No Start
this car turned into a time consumer,after running into the wall we asked our local bussiness across town to recheck our work and they did not find a cause either.after work one night i dropped off old cam and crank sensors so they could switch them and look a... |
6 |
|
2000 Subaru Forester 2.5L Convertor
A big thanks to all who replied! After taking a fantastic weekend enjoying the Knoxville dirt late model nationals, I stuck a couple long 8mm bolts in the convertor and worked it around. Had to pull it out a couple times and check things before installing new ... |
6 |
|
1986 Toyota Pickup 2.4L Excessive Emissions
First of all I would like to thank all of the professionals that sent a reply to my help request. Jeff from New Mexico and Doug from California nailed it on the head with the throttle position sensor being the fault. When I tested it I received absolutely no d... |
12 |
|
2005 Toyota RAV4 2.4L crankshaft/block
Most of the replies centered on select fit brgs.,checking the brgs. to see if they are undersize,& checking the block for possible warping,or misplaced caps. As I had stated,the crank was tight before even putting on the caps. Anyway,we came up empty,& will do... |
14 |
|
Prev
