|
1995 Honda Passport 3.2L Valve Lifters We have a Honda Passport/ Isuzu Trooper with loud lifter
clatter. We first followed the TSB on clatter for this
engine which included an engine flush, we then replaced all
the lifters, then the pick up screen was inspected, then
the oil pump replaced. I have d... |
View |
|
1997 Honda CR-V 2.0L Compressor/ Condensor fans Hello Honda Gurus. this thing is my lunch and dinner. Came
in with leaking radiator and 1 inop cooling fan. ASnother
tech repaired and customer requested to diag inop ac. A
piece of wire was stuck in pressure switch on drier going
nowhere. Switch was connected... |
View |
|
2002 Honda Accord 2.3L Cuts out Honda Guys - We have a severely intermittant stall/cut out
problem with this one. The car will randomly stall without
and warning and restart without a problem. There is no
rhyme or reason as to when it will cut out but always
restarts immediately after stalli... |
View |
|
1997 Infiniti Q45 4.1L Poor Idle Quality, Misfire, MIL Lamp on Hello,
Working on a dealer-owned car. Has been sitting back-row
since I last tried to diagnose the problem of
intermittently running poorly when hot, setting the
check-engine light. Begins to run rough with a noticable
miss and the check engine light then bec... |
View |
|
2003 Infiniti G35 3.5L radio and a/c hey i have this 2003 g35 coupe that the radio does not turn
on and the a/c is on full blast and can not be shut off. i
tried to take out the radio to see if i have power to the
head unit but i cannot get to the back of it. i had checked
all the fuses and the a... |
View |
|
2000 Isuzu Rodeo 3.2L MIL Lamp on runs great. condition is currently a hard failure, code
will pop on within 5 seconds of start-up. we've followed
alldata's diagnostic chart to the letter, and have replaced
ion ignition module. i've checked resistance per alldata on
every wire from pcm to modu... Trouble codes: P1312 (ion sensing module sec line 2 circuit fault). |
View |
|
1998 Lexus GS400 4.0L speedo customer brought car in with multiple problems,one of which
is speedo inop,this car has abs code for both front speed
sensors right sensor wires are broken,left is bad,abs bulb
must have been removed?car has 22 inch wheels.the problem i
have is knowing where t... |
View |
|
1999 Mazda Protege 1.6L drive ine hi guys This is a vehicle i have serviced forever and it
came in with a rumbling noise after 40 mph.
I replaced the r side axle bearing a few months ago. I
disconnected the left axle and the bearing which
was noisy so i replaced it, the noise didnt go away s... |
View |
|
2001 Mazda Millenia 2.5L MIL Lamp on Help Mazda techs! This mazda has an on going issue with
mil/ egr issues. We have never duplicated a malfuntion in
the system but customer has opted for a new valve and
soleniods. All passages are clear- vacuum is good- with new
parts car went approx 3 weeks wi... Trouble codes: p0400 (egr flow malfuntion). |
View |
|
2004 Mazda 6 3.0L Cooling Systems I got an easy one here for those experienced with Mazda.
I'm doing a waterpump on this car and I cant figure out how
to get the cam pulley that drives the water pump off. It
looks pressed on and it is in the way of the upper two
waterpump bolts. Do I need a sp... |
View |
|
2000 Mitsubishi Galant 3.0L 1-2 Shift This [F4A51] trans will shift OK in all forward gears under
normal driving, but on heavy acceleration it will stick in
First gear. If you leave the throttle down it will slip.
When it is stuck in First the PCM is giving a first gear
command to the Solenoids.
... |
View |
|
2002 Mitsubishi Montero 3.5L Cuts out, Stall hi guys. i have a head scratcher here ( for me at least).
this 02 montero limited was running good no problem, the
customer brought it in for tune up + timing belt. so we did
both at the same time. the problem we are facing now is the
truck will stall(pass out... Trouble codes: p0335 (crank sensor), p0340 (cam sensor). |
View |
|
1997 Nissan Altima 2.4L Excessive Emissions, Poor Idle Quality, Stall hello techs This car came to me with what I thought would
be a simple problem and it has eaten my lunch.I have spent
more time than I care to tell you.Customer complaint is
intermitent stall at idle.no codes. The car dosent idle
rough it just idles slow and st... |
View |
|
2002 Nissan Altima 2.5L Poor Idle Quality Woll gents and Ladies this is my first post asking for
help. So thanks in advance for your time reading and
responding to this help request. I have tried reseting the
idle learn procedure as stated in Mitchell with the old
unit, however this did not work. We r... Trouble codes: PO442 (evap leak replaced fuel filler neck repaired), PO507 (idle higher than normal). |
View |
|
1991 Subaru Justy 1.2L Starting Intermitant no start, I am not a Subaru tech and have been
trying to figure this one out I have checked and repaired
the wires to the dist at the connection [ someone had
previously taken out the connector] checked the resistances
on the pickup coil and the cr... |
View |
|
1998 Toyota Camry 2.2L Converter lock Have a Camry that keeps setting P0773 (Shift Solenoid E
Electrical Malfunction (Shift Solenoid Valve SL).
I have checked continuity from ECU to Shift Solenoid E
(Lock up Solenoid next to selector shaft) and that single
wire checks good. I have replaced the Lo... |
View |
|
1998 Toyota 4Runner 3.4L brake paddle problem: long distance brakeing. example: if there is a car
suddenly stop in front, i'll have to apply brake paddle so
hard as if there is no power brake. but if during a regular
stop and go, would not even notice there is a brake
problem. i don't have guage t... |
View |
|
2000 Toyota Celica 1.8L MIL Lamp on I must admit that as an all make tech of 25 years, some of
these evap systems really make me crazy! I have looked at
the good info on Toyota evap diagnosis in the tech resource
section but still having problems with this one. We fixed a
leak problem a while ba... Trouble codes: p0441 (incorrect purge flow detected). |
View |
|
2001 Toyota Celica 1.8L MIL Lamp on well we have this celica gt with the check engine light on
we have checked it out for leaks seems okay ive tested all
the solenoind evap vent ccv solenoid and the only one im
not sure is the vsv at the canister all data doesn't say
what the ohm's should be,it ... Trouble codes: PO440 (evap control system problem), PO441 (evap system purge flow low), PO446 (evap vent solenoid problem). |
View |
|
2003 Toyota Sequoia 4.7L Warning Lamp Vehicle came in for brake warning lamp on. Check fluid,OK.
Vehicle has all new brakes. Upon start up light is off
after driving for a while the red brake warning lamp comes
on and stays on. No info on brake indicator other that with
parking brake on it will il... |
View |