|Prev||Professional Automotive Repair Technical Discussions for October 31, 2006
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1998 Chrysler Concorde LX 2.7L MIL Lamp on VIN: 2C3HD46R6W
Fuel and Speedometer go dead and after awhile the odometer reads No Bus. We have been able to get codes 1698 No Bus message from BCM, and 1716 No communication with PCM. This happens intermittently. My tech had it happen yesterday, he went through the diagnost... Trouble codes: P1698 (pcm mil request), P1716 (tcm no communication with pcm)
|1998 Dodge Ram 2500 Truck 5.9L Surge VIN: 3B7KC2664W
Hello all, this is a good one for the Diesel experts (which obviously we are not). This truck occasionally acts up by getting very touchy on the accelerator. A minor touch on the pedal will make the truck jump forward. We had the scanner connected and TPS sign... Trouble codes: 1693 (DTC detected in PCM)
|1999 Dodge Ram 1500 Van 5.9L Poor Idle Quality, Hesitation, Surge, Cuts out, Stall, Misfire, MIL Lamp on, PINGS VIN: 1B7HF13Z4X
this dodge originally came in for code po300 misc. cylinder misfire. test drive vehicle and unable to duplicate. find all ignition parts to be original. replace ignition parts and perform motor vac service. test drive truck, find no problems. return to custome... Trouble codes: P0304
|2001 Dodge Grand Caravan SE 3.3L Evap leak VIN: 1B4GP24371
Customer came in with MIL on. Code for very small leak was storede in memory. I have run though the system, plugged off verious componants and have run the on board tests multiple times. At this point, I can run the test without touching anything and will pass... Trouble codes: P0456 (Very small evap leak)
|1998 Jeep Cherokee Classic 4.0L No Start, Poor Idle Quality, Stall, MIL Lamp on VIN: 1J4FJ68S9W
Check Engine light on, customer had stated that IAC repairs were previously attempted, P0505 shows. Followed Chrysler flow chart in Alldata & 2 driver circuits failed check, so customer opted for a used PCM, AIS (IAC) motor replaced with a new O.E. unit, but v... Trouble codes: P0505 (AIS shorted to ground), P1698 (No communication to TCM over bus), P0700 (Trans. code set)
Fixes & Summaries for Chrysler
|1997 Chrysler Concorde 3.5L tcc VIN: 2C3HD56FVH
Hi Everyone, Well this one was an adventure but it is down the road. First I must thank all who replied, Bruce, Chris, Ted, Kyle and Robert who sent detailed info for checking whether it was a control issue or the convertor which the replies were split between...
|1999 Chrysler Sebring JX 2.5L factory theft system
it was the pcm replaced it and car runs good thanks for all the help car ran for 5 hours if it would start would allways die after 20 minutes
|1999 Chrysler 300M 3.5L heater VIN: 2C3ME66G3X
After reviewing the responses we decided that we had a problem with the control head or the mixture servo motor. I borrowed a control head with no change so i ordered a servo motor and after replacing it everything was ok. Thanks again for all of the responses...
|1999 Dodge Ram 3500 Truck 5.9L Surge, Cuts out VIN: 1B7MC3362X
Replaced the injection pump and it fixed the problem. We had already replaced the lift pump. Thanks for the replies. I needed that extra push to spend the bucks. Trouble codes: P0216 (fuel injection pump timing failure), P0380 (intake air heater 1 relay control circuit).
|2002 Dodge Durango SLT 4.7L Stall, MIL Lamp on VIN: 1B4HS48N32
The update gives information on our first of this two part problem, that the timing chains had jumped. The second issue that reared its ugly head once the timing chains were reset was that the suv would start and stay running, but quickly developed a rough idl... Trouble codes: P1391.