|Prev||Professional Automotive Repair Technical Discussions for April 15, 2006
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|1996 Ford Windstar GL 3.8L Cuts out, Misfire, MIL Lamp on VIN: 2FMDA5147T
p0340 only hard code,cam sensor wiring has been tested,all grounds back to pcm have been checked,cam sensor and pcm have been replaced,code always resets.found cam sensor out of sync.180 degrees,set up sensor to number 1 cyl tdc.now engine runs better,but p034... Trouble codes: P0340 (camshaft position sensor A circuit), P0133 (o2 sensor slow responce bank 1 sensor 1), P0153 (o2 sensor slow responce bank 2 sensor 1), P0420 (catalyst system efficency below threshold bank 1), P0300 (multiple cyl misfire)
|1997 Ford Windstar 3.8L door locks VIN: 1FER45YHUV
Greeeting to all Ford techs on this one... this windstar is not my specialty but here goes.. Customer complaint of no power locks, but if you work the power door lock switch the side door and rear door cycle until you manually lock them again. The two front do...
Fixes & Summaries for Ford
|1970 Ford Mustang 351CID power steering VIN: 0F04H14813
Thanks guys for all the assistance with my headache. The 'new' hydraulic control valve was defective, a second one restored the system back to noirmal operation, it now has normal asist in both diections and no sound of the presure relief valve in the pump ope...
|1997 Ford Aspire 1.3L MIL Lamp on VIN: KNJLT05H1V
The fix was pretty straight forward. I removed the upper intake manifold, the passage was blocked where the upper & lower manifolds bolt together. There is an orfice in the upper intake gasket, this where it was blocked. No need to remove the lower intake mani... Trouble codes: P1407 (egr system).
|1997 Ford F-150 Lariat 4.6L Cooling Systems VIN: 1FTDX1765V
hi fello techs : i had to take the heads of and reface the two heads and the valves ,everything thing is working find now thanks to every one .