|Prev||Professional Automotive Repair Technical Discussions for October 17, 2004
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1998 Chrysler Sebring JX 2.5L Misfire, MIL Lamp on VIN: 3C3EL45H1W
I need help from one of you Chrysler gurus. Car is misfiring on cyl #2. With a spark tester it has spark. with a noid light it has injector trip. All injectors ohm out right. Did a fuel injector cleaning and no change. Compression tested #2 155 psi. No oil or ... Trouble codes: 302 (misfire cyl 2)
|1997 Dodge Caravan 3.0L Lockup
Im concerned after doing 3 speed tranny rebuild, I rechecked codes. There was a code for converter lockup error. The vehicle has no tach. and its difficult for me to tell if lockup is occurring. I think it isn't giving the feel of lockup at 38 to 40 mph. It se...
|2000 Dodge Grand Caravan SE 3.8L Brake pads VIN: 1B4GP44G6Y
Hi everybody! I have a van here that is really bothering me. It came in with uneven wear on the front pads. The drivers side pads were much thinner than the pass. side. I replaced the calipers with Wagner thermo-quiet loaded units and replaced one rotor. After...
Fixes & Summaries for Chrysler
|1995 Dodge Avenger 2.0L Cuts out VIN: 4B3AU42Y8S
Sorry I am so late in closing this request. The car was ok when it was picked up by the customer, but the problem was very intermittant. I have tried to contact the customer for 2 weeks, but have been unable to do so. Therefore, I will close this request and a...
|1998 Jeep Cherokee Sport 4.0L No Start VIN: 1JF4FJ68SX
Thanks to all that replied. As suggested, there was a sensor shoted to ground and causing the computer to become inoperative. As I went around disconeting each sensor I found that the crank sensor was the one causing the symptons. Replaced the crank sensor and...