|Prev||Professional Automotive Repair Technical Discussions for October 16, 2004
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1995 Dodge B2500 5.2L sputtering VIN: 2B6HB21YXS
van has sputter on intial take off. also noticed intermitten rough idle on start up. has new cap, rotor, wires, plugs, egr, air filter, pcv, and fuel induction service performed. fuel pressure is good, however did notice slight spitting in fuel volume test. ha...
|2000 Dodge Ram 3500 Truck 5.9L No Start VIN: 1B7MC3365Y
Hey guys, I drew a blank with the archives. Extended cranking time cold and intermittant no start after hot soak. There are no codes. It seems to take on air though I can find no wet spots. When the engine doesn't want to start, the lift pump will only run ab...
Fixes & Summaries for Chrysler
|1999 Dodge Intrepid 2.7L Mechanical VIN: 2B3HD46RXX
Most said to run from this job I took your advice and told him I would only replace it with the same engine it's not worth all the headaches that I have heard about and I will have to stand behind my work so I am putting another 2.7 in this now. Thanks for all...
|2000 Dodge Neon High Line 2.0L heating VIN: 1C3ES46CYD
this one is done---had to shake my head and pay attention!! the heater core was restriced we were too fast when we felt the hoses both were hot but if you paid closer attention the return was a little bit cooler.we back flushed the core and it seamed to have s...
|2003 Dodge Dakota 4.7L Interior VIN: 1D7HG38N73
Hi all... Sorry for the delay in posting this fix...I just got the part yesterday.I replaced the Central Timer Module and now all is fine.Thanks again for all the input on this one..it's very much appreciated. Thanks, Dane
|1995 Plymouth Voyager 3.3L Cuts out, Misfire VIN: 2P4GH25R7S
Sorry for the time delay posting this fix. Received lots of excellent feedback. Problem was a broken flex plate. The center of the flex plate broke and allowed the crank and cam sensor to become out of sync. We received on post on this being a possiblity but I...