 Prev |
Professional Automotive Repair Technical Discussions for August 27, 2004 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 1962 Dodge lancer 225CID cylinder head VIN: 7327149212 Looking for someone with torque specs for this old beauty,especially the head. Thanks |
View | |
| 1998 Dodge Ram 1500 Laramie 5.2L Instrument cluster VIN: 1B7HC16Y1W Hi all, I'm at my wits end with this one, and need a fresh perspective on where to go with it. While testing wiper system, I plugged my scan tool in and the dash came alive again. I have tried just about everything to make it quit, to no avail. I did notice ... |
View | |
| 1995 Eagle Talon TSi 2.0L Stall VIN: 4E3AL54FXS Hello all, I have an interesting one here. Customer brought the vehicle in with a complaint of stall on decel stop. We test drove the vehicle and could not re-create the problem. We eventually found out that the problem occurs intermitantly under lighter stops... |
View | |
| 1999 Jeep Grand Cherokee Limited 4.7L Excessive Emissions, No Start, Poor Idle Quality, Cuts out, Stall, MIL Lamp on VIN: 1JGW68N0XC Greetings, This Jeep can in on the hook. The owner reports that the CEL turned on and it ran progressivly worse until it stalled. We scanned and got the codes listed plus a 523, oil pressure voltage too high. The jeep will start, it runs bad and worse as it... Trouble codes: 113 (IAT over 4.9 volts), 118 (ECT over 4.9 volts), 123 (TPS over 4.5 volts), 1492 (Battery temp over 4.9 volts), 463 (fuel level sensor over 4.9 volts), 1594 (Battery over 15 volts) |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 1998 Chrysler Concorde LXi 3.2L battery VIN: 2C3HD46J5W Well this vehicle was very time consuming regarding the time it took to find the draw. 4 replies in total, Joseph had the best reply to set my meter on min-max setting and check it periodically, and sure enough within 50 minutes it spiked at 843 ma. We proceed... |
4 | |
| 1999 Chrysler Sebring 2.5L Poor Idle Quality, Hesitation, Misfire VIN: 3CEL55HSAT thank you for all help. put the distriburtor in. road test start the car cold all good. went back to the customer and customer is every happy with car. |
8 | |
| 1997 Dodge Caravan SE 3.0L Boils over VIN: 2B4FP253XY Several of you nailed it pretty darn close. The radiator cap tested good, but when hot it would bleed past the internal seals. The radiatior was partially plugged, Cleaned it out by backflushing with a hose. The bissest problem was the coolant mixture was too ... |
35 | |
| 1998 Dodge Durango SLT 5.9L colling system VIN: 1B4HS28Z8W Sorry it took so long to get back to you. Yes I looked at the fan clutch after talking to the customer some more the fan clutch was replaced at one of the other repair shops with a aftermarket part. Was unable to covince the customer that the fan clutch was th... |
14 | |
| 1999 Dodge Neon High Line 2.0L Poor Idle Quality VIN: 1P3ES46C4Y found egr pintle not close, clean egr pintle and ports, problem now gone. thank you for helping me with this problem. |
8 | |
| 2001 Dodge Ram 2500 Van 5.9L rear axle VIN: 3B7KF26Z61 A big thank you to eveyone who replied. In my original post I failed to mention that I had put additive in after I had checked the ring and pinion and related parts. What I did not do was to remove and inspect the clutches on the side gears, which I did this m... |
11 |
