Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for August 26, 2004
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
1988 Chrysler Conquest TSi 2.6L Hesitation, Cuts out, Stall VIN: JJ3CC54N4J
when we got the car found the mass air flow was damaged so the customer got us another mass air flow which both were used and both reacted exactly the same. we have limited information on this vehicle in our shop. i have checked fuel pressure and it is good th...
View
1997 Dodge Caravan SE 3.0L Boils over VIN: 2B4FP253XY
Van came in for overheating and boiling over. Found a broken thermostat and vehicle failed block test. New thermostat and head gaskets with milled heads. Van still boils over but does not overheat. It only boils over when you idle for an extended peroid of tim...
View
1997 Dodge Ram 1500 Truck 5.9L MIL Lamp on VIN: 3B7HC13Z4V
This truck is not an enhanced evap system.It does not have a LDP or a vent control valve.It has a cannister and a mechanical vent to atmosphere along with a purge solenoid.This Truck was just purchased a couple of months ago and this has been a problem since.O... Trouble codes: P441/
View
2000 Dodge Caravan 3.0L brake pads VIN: 2B4GP2530Y
This van has gone through several sets of brakes in the last two months. I'v replaced the pads and rotors 3 times, I'v replaced the caliper with a heavy duty caliper. I put on top of the line parts from Raybestos. I was told that it may be a hose that is colap...
View
2001 Dodge Ram 2500 Van 5.9L rear axle VIN: 3B7KF26Z61
Hello tech's, I have a truck in my shop that has a very audible popping noise when the truck is at low speed, mostly while in reverse, and the wheels are turned. It will occassionaly do it in drive. I have had the axles out and inspected the splines, ring and...
View
2001 Dodge Ram 2500 Truck 5.9L Cuts out VIN: 1B7KC23Z51
This is a municipal city vehicle with an intermittent complaint of "dying out, like you shut off the gas and start to pull off the road, then it will pop and go back to normal" according to the one man who drives it. Its intermittent and all I have felt on mul...
View
2000 Plymouth Breeze 2.4L abs VIN: 1P3EJ46X4Y
The ABS kicks in on this AT TIMES just before final stop. No codes. Have looked at all tone rings. All 4 wheel speeds on scanner show the same even when acting up. Quite sure we have a glitch in 1 of the four sensors but guessing is to expensive. Also, sensors...
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
1990 Jeep Cherokee Limited 4.0L Master Cylinder--replaced with standard brake m/c- VIN: 1J4FJ78L3L
This problem has not ceased or left us. We have found another jeep with standard brakes and had it towed to our shop for comparison and for brake parts to test on the vehicle that we have. Dave [...] had mentioned that there were two holes in the brake pedals...
5
1993 Jeep Cherokee 4.0L Poor Idle Quality, Surge
Customer was going to take her computer back for warranty at Autozone but the warranty expired. She decided to take the vehicle back on Friday. She called me on the following Tuesday and said that Jeep had never run better? 'It must be a Jeep thing that I don'...
5
1996 Jeep Cherokee Classic 4.0L No Start, will not comunicate VIN: 1J4FJ68S3T
I am sure glad I knew where to turn when I needed help. This was a common problem according to the 12 replies recieved. The crank sensor on this Jeep was shorted and causing all the problems. I would like to thank Jerry [...]...
14
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next