 Prev |
Professional Automotive Repair Technical Discussions for November 27, 2018 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for European
| Help Request | Answers | |
| 2011 Mercedes-Benz E350 3.5L starter VIN: WDDKK5GFXB The vehicle will intermittently not crank or will crank and then stop, Battery is new and charged Key fob battery is new, some times repeatedly pressing the start will start it and then it may be days before it acts up again. There were 3 pages of codes in... |
View | |
| 2014 Mercedes-Benz Sprinter 3500 3.0L MIL Lamp on, No power VIN: WD3PF1CC6E Van came in on the hook. Customer complained about a bad leak. We inspected and found the plastic fuel line coming off of the fuel filter was leaking. We replaced the line and went to test drive and then we get the 2 codes P11B900 and P11BD00 immediately o... Trouble codes: P11B9, P11BD |
View | |
| 2015 Mercedes-Benz ML350 4Matic 3.5L Uneven pad wear VIN: 4JGDA5HB4F LR outer brake pad went to metal in 14,000 miles. sensor did not deploy. Front pads have 50,000 miles and are at about 20%. We replaced rear pads at 36,000 miles with Texars. Pads measure LR outer 0 mm, LR inner 3 mm, RR outer 4 mm, RR inner 5 mm. Caliper ... |
View | |
| 2009 Volkswagen Tiguan SE 2.0L MIL Lamp on VIN: WVGBV75N89 *please read entire post, not a vacuum leak! setting lean code intermittently..fails basic setting 107 intermittently. basic setting 32 group 1..lamda learned value at idle 3.4 group 2..lamda learned value part throttle goes over 10 after short cruising.... Trouble codes: P0171 |
View |
Fixes & Summaries for European
| Fix/Summary | Answers | |
| 2012 Land Rover LR4 HSE 5.0L timing VIN: SALAG2D49C Thank you for the input, I did not add to my thread that yes the chains were replaced. I have always done together my bad. Jeff had good thoughts about the sludged bolts. Mine were ok. I'll keep that in mind though. Chris helped with the reuse of tensioners. H... |
10 |
