 Prev |
Professional Automotive Repair Technical Discussions for November 26, 2018 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for European
| Help Request | Answers | |
| 2005 Audi A6 Quattro 3.2L Misfire, MIL Lamp on VIN: WAUDT74F55 This Audi will start up cold and occasionally run for a few minutes and set a code P2296 for a short circuit to 12V on the fuel pressure regulating valve (N276). When it does this the data on measuring block 140 is as follows. Channel 1, the fuel regulatin... Trouble codes: P2296 (Fuel pressure regulator valve N276 short circuit to B) |
View | |
| 2004 BMW M3 3.2L MIL Lamp on, goes into limp mode Ok so this isn't a very ordinary car and we aren't a very ordinary shop. We do lots of track and race cars (BMW) and this is a client's new to him car. The actual car is an E90 series 320d but is pro built Latvian enduro car.It runs the popular S54 (2004 b... Trouble codes: 195 (Fault code is also called C3 deviation step torque from actual torque) |
View | |
| 2006 BMW 550i 4.8L Suspension VIN: WBANB53596 BMW Tech, please help on this bad boy here. Customer concern Dynamic Drive light on. Found front axle pressure too low & rear pressure too high.No major leak found in system, only minor seepage found from front stabilizer bar. We suspect a valve block bloc... |
View | |
| 1965 MG MGB 1.8L Clutch VIN: GHN3L28007 Need some advice on bleeding the clutch on a MGB. Car came in customer replaced clutch slave and master but had no clutch pedal. We bleed system and got some pedal but not much found slave was leaking fluid. Replaced re bleed and still no good. Replaced ma... |
View |
Fixes & Summaries for European
| Fix/Summary | Answers | |
| 2000 BMW 323i 2.5L MIL Lamp on VIN: WBAAM3344Y I have finally got this car out the door without any issues. Thanks to Alan [...] about the info about the hose at the rear of the manifold that goes to the LDP. This was the vacuum leak that I heard. I replaced that hose, and cleared codes to see what woul... Trouble codes: P1477, P1477, P1477, P1477. |
10 |
